The story begins with a portable hot-wind gun, which was bought in order to learn how to make a flash drive with bga, five flash drives in one breath, enough for me to use it for a long time, and then i've been idle, and i've bought it for a small amount of time, but it's still a very cumbersome line and stubble
Here's my 936 welds. They've been making things, changing things. They've been used so much, they've become indispensable products in my life
So today it's a surprise to combine the two, so that one can save one plug, two can simplify the line, three can add a switch to the independent control, and four i want to modify the head of the wind gun, control it with a switch, and save another rack。
Every time a windgun is placed on this shelf, it's on hold, and every time it's put on it, it's very difficult. Hands
I don't know the structure of the windshot, but i guess it's made of magnets, so open it. Look
This thing is called the clarinet, which is the magnetic switch
It's the heating part of the windgun
A simple test. Under normal circumstances, both sides of it are unguided
Once the magnets get close to it, they'll be able to conduct the switch
Now give the windgun a new button switch
It opened a circle with an open hole
Whatever. Let's just stick it on
Let's do it
Welding is done, and it's done
And when the windguns were removed, they were so full, they couldn't get the switch, they had to be on the weld table. Off
I turned the switch on again, and it didn't look right
Welding lines, welding platforms, that's the effect
The outleted power lines were welded to the windgun and then installed, this time fixed with a 3m nanoglue, which was easily removed。
The end result is simple and clear
And it's not too messy. It'll look better if you put a winder on the tool wall
