Don't fire the fire in the fireplace
It's a pain in the ass when the fire breaks out. Don't worry, i'll help you analyze the possible reasons and provide some solutions。
Fragmentation: the pulsed fire extinguisher works normally, but no fire is lit, and the master controller also alerts the police to display the fail-fire code on the screen。
Possible causes:
The problem of ignition needles: the insulating china of the ignition needles is broken or the metal needles are loose, resulting in weak electrical sparks。
Gas valve power source anomaly: power supply is problematic and the electromagnetic valve cannot be opened。
The ratio valves are not set properly: the ignition currents are not regulated correctly, or the small flame gas flow of the sub-valves is not justified。
Gas valve jamming: gas valve valves accumulate foreign matter and are not functioning smoothly。
Proportional valve rubber drum membrane problem: aging or damaged rubber membrane。
Electromagnetic valve wire failure: short circuit or open circuit。
Gas pressure: excess or low。
The double-speed wind machine was wrong: the high-speed and low-speed line went backwards。
Ignition parameters are not correct: the ignition is too wide or too small, or the direction is crooked。
Solutions:
Replacement of ignition needles: if there is a problem with firing needles, change them directly。
Change master controller: sometimes problems arise on the master controller, try a new one。
Regulate proportional valve currents: adjust the ignition currents of the ratio valves to make them more stable。
Regulate the flow of sub-valves: the small gas flow of the sub-valves should also be adjusted。
Clearing gas valve alien: cleaning up the alien on the valve door。
Replacement of gas valves: if the gas valves are broken, change directly to new ones。
Replacement of electromagnetic valves: if there is a problem with the electromagnetic valve wire, change directly to new ones。
Reconciliation of gas pressure: keep the gas pressure at a rated value。
Check the double-speed wind lines: the high-speed and low-speed lines of the double-speed wind are to be matched。
(b) arranged ignition needles: adjusted to 3-4 mm if the ignition time is too wide or too small; adjusted or replaced if the direction is crooked; adjusted to make sense if the ignition is too far away from the burner。
I hope these solutions will help you solve the problem of fireless fireplaces! If you still can't, call a professional maintenance officer。
