Any electrical appliances must be powered to work. Electrics need to be plugged into the plug to get electricity. Although the plugs are very common and common, have you studied carefully how they should be installed? With this question in mind today, we are going to see with him exactly what the fit-out steps are and whether there is anything to be noticed。
Plugin installation steps
I. Cleaning of floor boxes. Plugs are installed after carpentry, etc., while long-standing bottom boxes inevitably accumulate large amounts of dust. The bottom box of the switch intubation is first cleaned and, in particular, the dust impurities in the box are removed and the remaining dust in the box is wiped out with wet cloth. This prevents special impurities from affecting the use of circuits。
Power line processing. Leave the lead line from the box for a length of repair and then cut out the core and be careful not to touch it. The steering line follows the clockwise steering wheel around the corresponding relay column of the switch or plug, then presses its head and requires that the core not be exposed。
Iii. Three-wire interconnectivity methods. Fireline access to one a mark in two holes of the switch, followed by an insulation line from the other to connect to the l-hole in three holes below. Zero-line direct access to the inside of the three holes. The surface is connected directly to the e-hole of the three holes in the hole. If the zero line is disconnected from the ground line, there will be a jump in the use of electrical appliances。
Iv. Plug-in stationary installation. The lead line from the box is first inserted through the exit hole of the plastic table and then the plastic table is attached to the wall with screws attached to the box. When fixed, the conductor, in his or her respective position, exits from the hole of the switch plug and presses the conductor as required. Finally, switches or plugs are attached to the plastic table, and the screws are fixed and the decorator is covered。
I. Locational care. In the kitchen, care must be taken that it must be far from the stove to prevent the heat damage; in close water locations such as bathrooms, balconyes, etc., care must be taken that the plugs are not low and should be covered with a splash-proof cover; and that no plugs should be fitted in specially wet, flammable, explosive gas and dusty sites。
2. Large power appliances shall use stand-alone outlets. Large-power appliances such as air conditioners, washing machines and oil smokers should preferably use a separate three-plug to prevent total circuit power from jumping. For seasonal appliances such as air conditioners, a switch plugin may be selected and, when not used, the switch may be closed instead of removing the plug。
The attention given today to the steps and installation of the plugins is detailed. The editor thinks everything about electricity has to be careful. So you should know how to install the plug before you can do it. It is hoped that the information on the steps to be taken to install the plugin presented to you today will be used as a reference to make it easier for you to install the plugin。
