I was about to show up in the kitchen, and the gas stove went off! Heartache
A lot of small partners can't handle gas stoves, and the first reaction is to find a way to sell them, and in fact, chief told you that these problems are solved by yourself, so easy。
One, you probably didn't open the valve
If the gas canals don't open properly, then the stoves can't
2. Closure of the closed valve
It is sufficient to remove the self-contained valve, which is marked with a green line and automatically closes when the red line position is set on fire again。
3. Shortage of gas
It's... You know, gas forms are down, just charge the gas. You have to keep in mind how often you look at it, how much you value it
4. Low gas gauge
Time to switch! Power
Replacement of a battery for your natural watch restores power supply, normal ignition, (the gas table is generally low as “valve shut-off-to-wire” or “low-off” valves)
Water in the stove
If the stove is wet by water, or if the fire covers, it can cause the fire to go off
Six. Fire cap jam
When a white ignition is discharged, but it is not normal to ignite the gas, it is generally caused by the failure to place or plug the small fire cover. At this point, the proper repositioning of the lids is basically normal。
If a small fire lid is blocked, it can be lighted with toothpicks or wires to purge the small fire lids and clear the alien inside。
7. Low power from gas stoves or battery leaks
If the white ignition does not properly discharge the ignition, the positive and negative contact points of the battery cartridge are checked for rust. If there is rust, it can be polished with sandpaper or a work knife and replaced with new batteries。
Be careful to remove the insulation cap from the battery
Seven steps above, quick check, simple work
But there's a cute little writer who's got a stove on fire, but he's always going to turn off the fire. Don't panic
The ignition pressure is too short
The pressure time is too short for the thermoelectric doll to feel the temperature of the fire, which may be triggered and automatically extinguished. Press the spin button first, then rotate, then rotate in three to five seconds and then release。
Two, the wind blows out the flames
When the gas stove opens a small fire, it may have been blown out by the overwind of the switch cabinet, which is suggested to be lighter and slower。
The door is sealed too tight
The gas stove cabinet door was too sealed to shut down, resulting in the burning of oxygen, and it was suggested that the cabinet door should have a vent and sufficient oxygen for the stove to burn。
4 - pots with water stains and oil
Gas stove boiler base or stove. There's oil stains. Flow into gas stoves, resulting in a fire out. Clean cookstoves and oil contamination should be cleaned before use。
Five. Fire cover jam
It's blocked. It's likely to end automatically. It can be used to decorate small fire caps and clean up foreign objects。
6. Thermal electro-puppet pollution
Thermal voltage is dirty, which may lead to the extinguishing of flames without feeling the temperature, at which point it is sufficient to clean out the golden voltage by the cover of the fire with rags or sandpaper。
In addition, fire colours are important indicators of the health of “gas stoves”, and normal flame colours should be light blue。
(above normal flame state)
(a) the flame is yellow: it may be a wind door problem, or it may be covered, it may be blocked, and parts of the gas stoves need to be removed, needles used, toothpicks used for cleaning and drying
The flame is red: it may be the gas that contains impurities or the climate is wet。
(flames yellow, black smoke)
The flame colour is abnormal and can be adjusted using the windgate
1. Raise gas stoves with two handled iron blades or knobs at the burner-nozzle link (as figure)
Two, one to regulate the fire, one to regulate the fire. (b) lightly dial the handle and adjust the size of the wind hole to change the flame state until the flames return to normal and the flame is blue。
Knock on the board. Has everyone learned
