We've got a power pressure pot in the shop, we don't know how to fix it, we don't all have to do it in a professional place, and it's more expensive!
Work process:
Set working hours ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
(computing menu and capacity) (heating lights, spin buttons backwards) (floating floats up) (pressure switch off at 50-80kpa, heat lights on, heat lights off)
- keep the pressure - keep the temperature
(intermediate power outbursts, heat-up lights and heat-pair lights alternately)
Frequent breakdown of electrical pressure pans and maintenance methods
1. Competing difficulties
Seal's not in place
The floater's stuck in the pusher and pushed the stick with his hand so that the floater could fall。
2. Difficulties in opening up
When you breathe, the floater doesn't fall。
Three, floats cannot rise
No float seal, no float seal。
Leak around the pan cap, check the pancap and the inner cap seal。
No inner seal, inside seal。
Four. Leak when floats rise
Float seals sticky with food slags, clean float seals。
Floating seals are worn and replaced。
Five, pan cap leak
Without a seal, put it on。
It doesn't fit, it fits。
The inside seal is sticky with food slag, clean with seals。
The inner cap seal is worn out, the seal is replaced。
The inner pan and the heat shield are at low levels。
5, 6 litres: 12. 6 ± 0. 3 mm. 3, 4 litres: 12. 4 ± 0. 3 mm。
Add a 1. 2 mm thick square to each shrapnel fixed column on the flex support structure, for a total of six squares, i. E., a pedal of high heaters, resulting in an increase in the garnish height。
6. Limiting pressure valve leakage
The vents are broken, the vents are replaced, and normal conditions limit the pressure valves from the top of the pan。
Limiting pressure valve pin break, replacing pin。
The limit valve is placed on the top of the pan, replacing the limit valve。
7. Limit pressure valve exhaust
The pressure switch is short enough to heat the pan continuously, when it reaches 95 ~105 kpa。
Emission limit pressure overhaul pressure switch pressure switch disconnection range, normal time: 60~80kpa。
Food and water are too low, and when power is out of control at work, the internal pressure in the pots reaches 95 ~105 kpa, which puts food and water as required。
Pressure switch disconnectors are extremely high and the pressure switch is overhauled。
The copper valve moves in with the pressure limit valves, which are placed in open water for about two minutes, and are removed and then pressured down on the plane, so that the copper valves are at the same level as the minimum point of the pressure limit valve lifting。
The thermostat short-circuit, overhaul the thermostat。
8. Dry or burnt food
The pan cap leaks, the pan cap and the seals are repaired。
Limit the flow of the pressure valve, overhaul the pressure valve。
When you cook, you set the cooking time too long, and you set the cooking time in the instructions。
Timer short circuit, fix timer。
Post-electric control panel no indication
Power plugs are in poor contact with the plugs。
Poor contact with internal connections, overhauling internal connections。
Supertemperators open the road and replace supertemperators。
Ten, keep the lights on
Temperature controls cut off, change thermostats。
11: the heating light is on but no heat
The heater breaks off, replaces the heater。
12: the heating time after powering is less than 3 minutes and the temperature lights are on
Timer or thermostat or pressure switch breaker, replace timer or temperature limitr or pressure switch。
13, when the heater and the heater are in the pressurized, the light is flashed frequently (the heater is on less than 30 seconds)
Pressure switch exposure is poor, replacement pressure switch。
