Henan nilone conveyance belt factory, henan nilone conveyor belt factory, henan nilone conveyor belt offer, reserved flight to rubber belt ltd
Low speed should be used as far as possible。
6 the flower diameter of the roller carrier shall be reasonably selected in accordance with the design requirements of the transporter, in relation to the transport belt layer, the roller, the re-director mix and the requirements for the slot angle。
7 the direction of the feed should follow the direction of the conveyor belt, sluices should be taken to reduce the impact on the conveyor belt when the material falls, and the gap should be reduced; the distance of the conveyor belt should be reduced and the leak should be covered by a buffer pad, and the conveyor belt should be fitted with a soft and moderate shield, so as not to overwhelm the sheet and break the belt。
8 the transmitter should be added and repaired in a timely manner when it is in use, if there is a shortage of pallets; the pallet is covered with material, which causes a failure to re-turn, prevents leakage between the roller and the tape, and pays attention to the lubrication of the part of the belt, but not to the oil-contaminated conveyor belt。
9 to avoid the delay of the conveyor belts, pillars or mass material, to prevent break-ups, and to apply artificial cotton for timely repair in case of partial breakage of the conveyor belts。
4. How to select a conveyor belt:
Accurate description of the name and nature of the particular material. In particular, particle size, temperature, ability to corrosive and special requirements such as acid and alkali. If the temperature of use is specified。
A description of the specific application, requiring specifications (wideness, length, layers, thickness, etc.), in particular the temperature and volume of the use of the heat-resistant conveyor belt。
5. How to transport storage belts
1 transport belts in transport and storage shall be kept clean to avoid direct sunlight or rain and snow leaching, preventing contact with substances such as acids, alkalis, oils, organic solvents and one metre from heat units。
2. It is desirable that the temperature of the warehouse at the time of storage of the conveyance belt be between 18 and 40°c and that the relative humidity be between 50 and 80%。
3. During the storage of the conveyor belt, the product shall be placed in a roll, shall not be folded, and the conveyor belt shall be rotated quarterly。
Henan nilon conveyor belt factory offer
