The way to reload the image of the vehicle is to: (1) first remove the power supply connection to the vehicle battery and place the removed connection at a distance from the electrodes in order to prevent accidental electrical connection; (2) and then determine the location of the installation of the vehicle-mounted camera, generally of two types: one in the position of a placard light, which is easier to install, with the small screws provided in the camera fittings being attached to the position of the lamp; and three or another in the frame, with the benefit of not drilling behind the vehicle through the metal, because the security bar is plastic, and the headline is relatively easy. Finally, the power lines of the camera are linked to the backlight power lines of the vehicle, then the video lines of the camera are linked to the video extension lines, the other end of the video extension line is connected to the input of the av on-board monitor, the battery power is restored, the car is activated, the vehicle is mounted with the reverse block, the reverse image can be seen on the vehicle monitor; 4 the owner cannot rely entirely on the back-of-the-horizon system to reverse the vehicle, but only as an auxiliary tool to reverse the vehicle; the vehicle-mount monitor must be properly connected, and if the monitor does not provide an av input interface, the corresponding video line or video-to-reswitch device must be found to allow the rear view to be properly displayed; and the vehicle-mounted electrical power is not easily connected to the vehicle-mounted bottle, so as not to cause electrical instability。
