There's a saying in the carbon-producing ring: "the tank is dead and alive." the chute is not well-opened, the front cut is perfect, and the back outfit is white。
Why is it so hard? Because the carbon material itself is “hard to handle” — it is high in hardness, it is very fragile, it is also electrical. An ordinary bed or manual tank is used, either on the edges of which the waste is lost or dust piles are buried with safety hazards. Many of the plants are not technocratic, they have no access to the equipment。
For many years, the zelig tank machine, deep-tilled carbon processing equipment, has offered solutions in three dimensions for the pain of these industries:
I. Specializing in the “fallside”
The main axis of the general equipment is not rigid enough, and the rate of rotation does not match the flow, and the carbon collapses as soon as it is retarded. It uses a sophisticated, high-intensity main axis, which is accompanied by a special blade and a micrometer grade to the system, and it cuts its face smooth and has no thorns and flat edges. The empirical data show a direct increase of over 30 per cent。
Specializing in “dust”
Carbon dust conductors, accumulated on the equipment circuit board, are time bombs. It also has a self-contained vacuum-absorption system, a dust-absorption system, a clean workshop and security. Workers no longer have to wear masks to do their work, and the productivity will naturally go up。
Efficiencies in the treatment
Full automatic numerical control and multiple slot processing in one load. Turns out it's half a day's work, and now the machine's steady for an hour. The key is stability — the products produced in the morning and afternoon are identical, not dependent on manual crafts, and mass production without pressure。
After all, it is not just machines, but product stability and workshop safety. The carbon-deductor is supposed to shut you down, and you're not afraid。
Sakazawa, focus on the carbon processing equipment, the opening of the tank is accurate and one step in place。
