Printers are a very common device in our lives to convert electronic documents into paper-based ones that can be carried easily. Printer ink is one of the raw materials of printers, and text cannot be printed into paper without it. So how do we put ink on our printers when they can't be used properly?
Ink price
First, if you don’t have ready-made ink powder, you have to go to the market and buy some. There are a lot of ink types and brands on the market. For example, china village online, the most popular ink powder is brother tn-2215. It's sold at 199 yuan, which is not expensive in all the big ink. Of course, most of the different ink powders need to be adapted to printers, otherwise they cannot be used properly. For example, the ink powder only fits brother 2240d/225dn laser printer or brother 7060d/7360d/7860d/7860nn multifunctional printer in a range of approximately 1,200 pages of printed paper. Besides, it's black。
Steps to add ink
When the ink is ready, we turn the printer off and turn off the power to ensure our own safety. Then it is determined that after the power has been cut, the printer's headcap is opened, a small button is pressed below the front cap, the powder box is removed at a time, and the parts that are removed need to be pressed on a small switch, which is on the left side of the front, and then separates the main part of the powder box from the powder box slot. Pick up the selenium drums in the disassembly parts and open them in a sealed area, bearing in mind that the seals are to be torn off before the lid is to be opened. When we open the lid, we add the carbon powder that was ready, and this process should be careful not to spill the ink, which is both wasteful and polluting。
In the case of ink powder, we need to note a few points, first of all, that the box should not be too full, otherwise the printer's printing efficiency would be compromised, and care should be taken to remove the lid, and not to use force to open it, which could easily cause damage to the printer parts, which could not be fully repaired. The other ink powder is slowly added, and the ink is soaked that it can cause environmental contamination in the surrounding area and can be dirty. When the ink is filled, we seal it up and then reload it back to its original position, gradually restore it to its original condition in accordance with the previous steps, and place the box back to the printer, so that it is fixed when the printer is back, and if it is not fixed, it will affect the operation of the printer itself。
Ink powder is actually quite simple, and the process of inkting can be almost clear from the presentation, and little can be done by paying attention to some of the above-mentioned concerns。
