Construction of yellow line white line, five centimetres of floor, six centimetres of yellow line, e

Work on the yellow line, the 5-cm floor line, the 6-cm yellow line, the 8-cm white line, the road line at the suzhou industrial park

The underground garage, the factory workshop or the warehouse terminal, and the specialized wiring system are fundamental to modern management. Construction elements of interior drawing lines and their importance:
The construction of the line in the garage consisted mainly of a lane guide line, a space partition line and a number spray. Thermal smelting reflecting paints are usually used to ensure that vehicles remain clear about the direction to be travelled in low-light environments. The drawing lines of the spaces need to be applied strictly to standard sizes, often white or yellow, with a width of 15 cm. Each parking space should be sprayed with a single number, allowing for rapid location of the owner and for property management. At the time of construction, attention should be paid to the cleanness and dryness of the ground to ensure that paints are attached。

The focus of the internal drawing line in the plant workshop is to distinguish between functional areas. Production fields, corridors, and temporary material storage areas are clearly defined through different colour lines. Yellow is often used for the corridor boundary line, green represents a safe area and red marks are prohibited or dangerous. Forklift traffic routes should be separately marked and operational safety enhanced with warnings. Most of these lines use epoxy resin or polyurethane coatings, which are resistant to grinding, pressure and slide。

The cargo line inside the warehouse and the forklift route are key to increasing the efficiency of storage. The position line needs to be precise to the size of the storage position, usually with a yellow or white line frame and precise management with a shelf number. Forklift passages shall be kept to a sufficient width (usually not less than 3 m), often accompanied by arrows indicating direction and edges with black inter-phase collision warning belts. Chemical plant areas also need to be marked with additional hazardous materials, with an enhanced warning effect using red and yellow slash lines。

For terminal discharge areas and temporary retrofitting of roads, it is necessary to balance high-intensity demand for use with temporary characteristics. The edges of the offloading platform are often sprayed with a black-and-yellow slope to alert personnel and equipment to high-risk discrepancies. Temporary road improvements require the use of fast dry paints or pre-fabricated cords to form fast orientation, diversion and speed limit markings。

Professional line construction not only optimizes space layout but is also an important security management measure. The selection of materials for compliance, standardized processes and clear marking systems will provide long-term, effective visual management support for various sites。

Contact: hui jui li telephone: 18015593357 tel: 0512-66062792 q: 277171599