Before we buy anything, we only know this thing well enough to choose it within a short period of time, so we can all look at what is available in all the water and electricity materials of the wholesale hardware, and once the list is clear, we can buy it all in one-off at the wholesale time, except for what are the techniques for repairing the hardware-stamping moulds, and what can be done when it is broken。
Wholesale of hardware and water
1. Raise hands
For closets, cabinets or bedside cabinets, hand-wringing is necessary for furniture fittings. There is now a wide variety of pull-outs in the market, and people can choose between what they like and what quality they do. Now there's copper, iron china, stainless steel. And the hand-carrying process is very varied. If you have a baby in your house, you'll protect the child from harm. Those circles or elliptical processes are usually selected. There is no sharp hand pulling, and for furniture, do not pull in the lower layer of design, and if the child does not notice, he/she will be hurt when he/she walks through the area。
Tracks
One of the most important things is the choice of track. The closets now have more options to push the door, and there is little use of the track. The general closet door is installed on the tracks. Owing to the high quality of the doors, orbiting is selected for quality clearance. So you can hold the closet door. The tracks also have copper or stainless steel. In order to increase the life of the track, it is to select the track of stainless steel。
You know, the hardware-stamp model maintenance technique
1. To measure the finished product that is finally pressed, to check the inspection criteria to determine the mutation, to check layout's measurement of whether the project size is the same as that of the mould, or whether the dimensions vary, and, if necessary, to measure the relevant work prior to and after the event in order to determine exactly where and for what reasons the variation was made, and to respond accordingly。
2. When it is not possible to determine or propose a response, the opinion of others shall be sought and no one shall be left to choose。
3. Overwhelming a. Sword grinding: rearming. B. Overstretching: most of the sides are emptied bands, with very low brightness and reduced gap. C. Material hardened: replace materials or increase gaps. D. Demolition angles: recoiling。
4. Size mutationa. Sword grinding: large hair or large size (trigger); small transformation (penetrating hole); poor plane level and re-write or replace flash. B. No guidance: no guide or other locator devices are functioning, the transmitter does not relax or have insufficient lead sales, cannot correct the guide, the locator block is worn out and the distance is too long. C. Inappropriate top-up: inappropriate top-up distribution, inappropriate or excessive spring strength, adjustment of impact or change of location or top-up volume, and elimination of short-term cooperation. D. Scratch deformation: material is distorted, size is increased or is asymmetrical。
There are some presentations in the article on the distribution of hardware and water materials, all of which are needed in the water and electricity sector, so that they will have to be purchased before the water and electricity can be removed, so that they can be made available in a timely manner and without delay, and what the repair techniques for the hardware presses are。
