Everyone must be familiar with the toilet, which greatly facilitates people's lives. The toilet has been in use for a long time, and there will be minor problems, such as leaking toilet tanks. If problems with toilet tanks are not resolved in a timely manner, they will accumulate a significant amount of water after some time, which will affect the sensitivity of the pressure valve and even the useful life of the toilet. What about the leak in the toilet tank? What's common about toilet water tank maintenance? These issues will be shared with you in the following article, which is expected to help friends in need。
What's the method of repairing toilet tanks
Problems with toilet tanks, if not addressed in a timely manner, could affect people's lives. If you want to fix the toilet tank, you have to start with a question check. When you press the water tank button on the tank to flush the toilet, the starting pole in the tank will be lifted, the pole will lift the puck or rubber cap at the bottom of the tank, and if the water valve opens, the water in the tank will flow through the rubber cap that has already been mentioned and flush it into the barrel below. When the water gushes from the water tank, the float ball that floats on the surface of the tank drops, pulls its arm down and lifts the valve plugs of the floater valve device. Floating valves rise as the water level in the water tank rises until the height of the floating arm is sufficient to press the valve into the float valve and to close the flow into it. If the water cannot be turned off, the excess water flows down to the barrel along the improved pipe to avoid spilling out of the tank。
The steps to repair the toilet tank are detailed
It is believed that many people have experienced this situation, and when you press the water tank, the flow of water from the tank into the barrel continues to cause waste. In this case, you can lift your arms up. If the water ceases to flow, the problem is that the balloon cannot rise to a sufficient height to press the valve into the flounder valve. One of the reasons for this may be the friction between the wall of the balloon and the water tank, in which case a little bending of the arm and leaving the flounder valve on the side of the tank。
The steps to repair the toilet tank are detailed
Then, if not, hold on to the floating arm and turn it against the clockwise, and shake the ball from the end of the arm to see if it does, because the weight of the water makes it impossible for the ball to rise normally. If you enter the water, throw the water out and then reload it back from the new float arm and replace it with a new one if it is damaged or corrosive. If there is no water in the float, reload it back to its original position and then bend it gently down to a sufficiently low position to prevent new water from entering the tank。
The steps to repair the toilet tank are detailed
If none of these methods can be solved above, then look at the sink plug. This is because water tanks have been used over time to produce a number of chemical impurities that may prevent the pellet from moving to its proper position, or because the pellet itself is decayed and the water will seep through the opening of the flush valve to the lower barrel. The closed valve of the flush toilet is closed and then flushed and the tank is empty. Now you can check if the water tank plume is worn, and you can install a new game if necessary. If the problem is caused by the opening of the flush valve and by the accumulation of chemical residues, please remove these residues with some dipped or non-drinked sand cloths, wire brushes or knives。
The steps to repair the toilet tank are detailed
If the above-mentioned steps do not solve the problem well, you will have to check the position of the steel rope from the plume, which leads to some angle of the plume and opening, and to the opening, make sure that the rope is directly above the opening of the flush valve。
