How are the batteries of small electric loaders maintained and repaired? The wind
It is well known that there are two types of power units for moving vehicles, i. E., internal combustion, which have the advantage of having a high load weight, which allows for large-scale handling operations, while the latter are less noise- and non-contaminated and are more suitable for short-distance handling operations. In terms of maintenance, there are also significant differences between the two, so let's see below how the small electric loader batteries are maintained and repaired
First, all small electric loader batteries are rotated out of the hood before being used, and small holes are kept open without the cover. The temperature of the electrolyte added to cooling should not be below or above 32 degrees; the electrolyte is made of sulphuric acid and distilled water; sulphate is used for the exclusive use of batteries, and other sulphate and water formulations are banned for electrolyte。
Normal charging of small electric handling vehicle batteries: the electron temperature shall not exceed 45 degrees during the recharge period, otherwise the chargeable current shall be reduced, stable artificial cooling shall be performed, or the charge may be suspended, provided that the initial charger's battery shall not be terminated for 12 hours from the start and that the suspension shall be avoided to the extent possible。
The determination of the full charge limit of the small electric handling vehicle battery is that the weight of the electron and the end voltage of the battery remain unchanged for more than three hours (about 0 or 10 times higher than the initial charge). Air bubbles occur evenly above and below the polar plate, and the electron is slightly luminous with milk whites, which are quickly and sharply ejected when the standard capacity 0, 1 current values are recharged after one hour。
Maintenance of small electric handling vehicle batteries: the battery shall be recharged immediately after discharge for up to 24 hours; the battery shall be strictly prohibited from being discharged or overcharged; the electrolyte height may be checked for retorted water supplementation if the electron is insufficient and charged for 20-30 minutes, in order to allow sufficient mixing of the electron fluid and to avoid the charge of electrolyte, in order to cause excessive concentrations and damage to the battery。
The above-mentioned points are about the maintenance and repair of small electric handling vehicle batteries, and it would be useful to know about the equipment. In addition, in the event of failure of vehicle batteries, they should be sent to the maintenance point in a timely manner. Large branded vendors, such as the permanent forklift supplier, should also be selected for the purchase of moving vehicles。
