When honda is 5,000 km away, there is a maintenance light indicating that only maintenance removal is required. The operational steps are as follows: 1. Start the vehicle, handle the operation and find the settings. The brightness operation of the dashboard is to open the vehicle's large lamp, the control pole on the side of the rotation dashboard, the clockwise screws up the brightness, and the reverse clockwise wane; the environment table is a system of energy-efficient driving aids, which helps drivers to improve their energy efficiency and fuel economy;2 the vehicle setting is found in the setup;3 the initial value is restored by replacing the vehicle maintenance information in the vehicle setting. Another method of eliminating the mind-maintenance light is: (1), to place the power of the mind-field in the o. M. Mode; (2), to press continuous display information buttons; until maintenance occurs on the display screen; (3), to press enter, followed by engine oil monitors on the image; and (4), finally, to hold enter at the end for about 10 seconds, the situ oil wrench will be eliminated. If oil has reached its limit, it needs to be replaced immediately. Replacing oil from the base of the vehicle: 1: first, remove the base of the vehicle; at this point, remove the oiled screw from the shell, remove the oiled oil from the oiled oil; then remove the oil from the oiled oil from the oiled oil; 3: screw the oil, be careful not to overstretch, prevent the screwdriver from being damaged; 4 - once the oiled tank is placed below the vehicle, the old oiled oil is released completely; 5 - remove the old oil filter and reload the vehicle's base, reload the vehicle; 6 - the oil filtration core is removed and the time needle is rotated; 7 - a part of the rubber coil on the edge of the oil filter is coated with a sheet of paper, then the engine is removed, and the oil on the engine is seen in the right place. Only conventional oil work pressure can ensure that any friction elements that are too high or too low to carry oil to the surface of a car engine will have a direct impact on the normal work of the engine or even lead to damage to parts of the engine. Therefore, when alarms are issued for oil lamps, the search should be shut down before the failure detection is sustainable。
