Marked 307 sedans (2001-2008) with zero maintenance lights
The fuel maintenance lamps marked 307 cars as zero are shown below。
1 place the ignition switch in the "offf" position。
2 press and maintain key "a" as shown in figures 4-8。
3. Place the ignition switch at "on"。
4 continue to press key "a " 10 s。
"0" and "snner" on 5 monitors', the symbol will be removed immediately。
East wind signs zero for 307 cars
1 turn off the ignition switch。
2 press the single schedule to zero on the combination instrument and keep the button as pressed。
3. Open the ignition switch。
The 4-mile meter screen starts to count backwards. When the display screen displays " 000. 0 " , release the button, when the wrench light in the display screen that indicates maintenance should be extinguished。
Note: when this operation is completed, if the batteries are to be cut off and wired, the vehicle must be locked and at least 5min must be waited, otherwise zero will not be recorded in the control unit。
Mark 207 car maintenance lights to zero
Upon completion of each maintenance of the 207 sedan, the maintenance sign shall be zero as follows。
1 turn off the ignition switch。
2 press the single mileage table to zero button。
3. Open the ignition switch: the mileage display screen will start countdown。
4 when displaying "=0" on display, release the button and the maintenance wrench sign is extinguished。
Marked to 206 sedans (1998-2008) with zero maintenance lights
The oil maintenance lamps for 206 cars were marked to zero as follows。
1 place the ignition switch in the "offf" position。
2 press and keep key "a" as shown in figures 4-7。
3. Place the ignition switch at "on"。
4 continue to press key "a"10s。
The “0” and “panner” symbols on the monitor will be removed immediately。
The maintenance lamps marked 206/306/406 were converted to zero as follows。
1 place the ignition switch in the "offf" position。
2 press the mileage to zero button a with your finger。
3. Place the ignition switch at " on " (hold a button unset)。
4 hold on to about 10s。
Five miles means ten, nine, eight... Countdown until. So far, and the “spannfr” maintenance light has gone out。
Six to zero miles, turn off the ignition switch, pull out the ignition key, and the maintenance light is zero
