Friends who like to play games know the siberian brand. This is the world's most famous professional brand of electric competition, and siberia sponsors and participates in many electronic competitions and events every year to promote the development and growth of the electronic arena. In the previously concluded s5 season of the heroes league, the headphones that professional players wear are siberian headphones. It's about the siberian headset maintenance method that works in life。
I. Methodological methodology of the creaking of the siberian elabor
For the siberian earphones where the membrane collapses, with a twig and a little bit of double-sided glue, gently glues the place where the membrane collapses. Note the size of control. When the membrane is restored, reload it as it is。
Ii. Methodological methodology of breaking of siberia's elem
There is little likelihood of a cracking of the siberian ear membranes, and even the sound can be damaged. Successfully managed, however, the sound damage was less significant. It's a little 704 glue (also called silicate sulfide glue) applied to the crack. Be careful not to be too thick to cover a crack. Then put the shell on. Do not try immediately, but do so after two days. Because silicate is drying up slowly。
Iii. Methodological methodology of destruction of the siberian elabor
Siberian ear membranes are detached, covered with 704 or a little bit of fish glue, and can be glued. Watch out for sticky pressure. Load back to place one day。
Iv. Maintenance methodologies for intelligital elements in siberia
Siberian earpieces were filled with iron powder, which was watered with cotton tags and then treated for membrane collapse。
V. Methodology of maintenance of the siberia hospital class
If the headphones don't sound, measuring the wire is good. The two welding points behind the measurement unit are not directed. Then the ring is cut off. Now the vast majority of earplugs, which are usually drawn from the side, have a slight effect on the sound, but have significantly reduced the likelihood of breaking the coming line. Nevertheless, the units are often cut off by artificial factors. A blade can be used to unplug the membrane, and the sound wire can be activated with a needle. Separate the two lines and then rip them out in the opposite direction of the circuit, with great caution. The direction of the two lines must be different. If you can't pull it, don't pull it hard, but use a thin ear wire to stretch the ring. It would be preferable to have a magnifier aided by a wire coating of tin online, followed by a sharp iron welding of the wire. The wires were also attached to the ear membranes with 704 glues. The ear membranes are then glued, and the two wires drawn are welded on the back welding points. It would be better to protect the line behind the pins with thermal soluble to prevent further cuts. The recovery of copper rings on the general membranes will have a higher success rate and will have less impact on the sound。
These are the methods of repairing the siberian headphones that the editor wanted to share with you, in addition to which he concluded his post by sharing the maintenance techniques of the headphones. First of all, when using headphones, don't pull hard, take care of them, and then always clean them, so they're good for ears, so they're healthy for ears, and then you can put a little drying agent in the headphones, so that rubber doesn't get old and deformed。
