A lot of people go to the mechanical watch, with durability and mechanical affection. But for three or five years, the trouble comes: no time, no time, no time, no time. It's not really a big problem. It's not a big problem. It's a problem。
Mechanistic watch travels in error, so don't rush for repairs. The most common is “magnetic”. Put the watch next to the computer, close to the electromagnetic furnace, and the magnetic field binds the cores together, moving quickly or suddenly. Buys a few dozen pieces of a “magnetic rider” that can be mostly restored; without it, only a watchmaker can be found。
Inadequate power also leads to irregularity. The manual swirling of the watch slows; the automatic watch slows if the arm moves less and can't turn. The manual watch is fixed to a slight resistance per day; the automatic watch is worn for eight hours per day, and the long-suspendant groups occasionally shake their wrists or make it up manually on weekends。
The wear and tear of spare parts should not be overlooked. Five or six years without maintenance, core gears, axle bearings are worn, and the mud is drying up, and it is becoming increasingly difficult to walk, requiring repairs, spare parts and oil。
The upper chord won't move, and the twist might break the watch crown gear. The automatic watch may be "sine-protected " , and the hyper-string design makes the top full of power and the back of the air, which is normal, and does not twist. Manual watch or automatic watch emptying of carden may be “chip rust”, when the handwatch water is not processed in a timely manner and the parts are stuck with rust, which is to be repaired at a time when the rust proliferation is more expensive to repair。
The upper string is inelastic, the upper string is loose, the walk is short, and the probability is "failed". The watch fell or did not change hair for more than a decade, and metal fatigue broke, requiring replacement。
The ash is present on the pallet, and a small amount of ash may be an ageing shell seal, with dust entering from the cracks without affecting the core; the ash may be too high and fibres, small particles, which may not be allowed to go in the gears, to be removed and removed and sealed。
The glass fog indicates that the watch is watered. The occasional spilling of water and the immediate drying of the air vents, the disappearance of the half-day fog, and the failure of the seals and the infiltration of the water into the core of the machine, require immediate repair. The master will remove the core and dry it, check the rust and change the parts。
Many mechanical watch problems stem from inadequate maintenance, bearing in mind three maintenance methods。
Avoid extreme conditions, with no surface bubble springs, no steaming saunas, high temperatures that age the seals; stay away from the strong magnetic field; and do not fall, do not crash the mirrors and the crown。
Periodically changing the seals, using a mechanical watch for three to five years, and even if there is no obvious problem, it is recommended to send a replacement shell seal and to check the core of the machine for dozens of dollars to avoid major problems。
Manual chords are soft, the manual watch is slowly wrinkled to a slight resistance per day; automatic chords are overdressed and the number of manual chords is reduced。
In addition, even if the watch is safe, it is recommended that full maintenance be performed on a regular basis to remove the cores of the machine to clean the sludge, change the ageing parts, and use the specialized watch oil. Spending small money makes the watch more accurate and life-long, and is cost-effective compared to major problems。
The mechanical watch is sophisticated, but it is normal to wear minor defects without stress. Remember that “judging the cause, then treating the illness, and maintaining it on a daily basis” will allow the watch to remain with us for a long time, with less expense。
