The flying fortress clean-up course。
Hello, everyone. Let's do a little dust removal for the fortress。
• turning the screws off of the backcaps first, suggesting that you divide the screws in one box, because the length is different。
• then, with a very thin crowbar and blades, first from a corner, and then out of a hole in the thin blade。
• use a harder crowbar to open up the place a little bit, and this one will have a few buttons, and it's a little bit to pull out the back. It is still relatively simple to remove the radiator directly from the cover。
The back covers have been removed, and the structure inside is so that it must be kept in mind that the batteries should be disconnected without electrical operation, or dangerous。
• to remove the screws of the fan and some screws on the radiator, at this point, too, because the lengths are different, the fans are well divided with the fans, so that they can be removed。
• then take out the upper and lower pellets and spend some time cleaning up the fan and cleaning up the dust inside。
And then you have to wipe out the original silicon resin and the radiator。
• it is now necessary to put on the guiding resin after it has been emptied, bearing in mind that the most important purpose of dust removal is to paint this thing, which is conducive to the dispersion of heat, and that it is useless to remove the heat if it is not。
· when the fan is evenly painted, then the fan is loaded, and then the thin copper pipe is packed, because the thin copper pipe is pressed against the fan, and the line of the fan is attached, so it can be installed at this time。
• it is then possible to turn the screw back in order, which is still simple to remove, just to remove the cover。
• fix these screws with a screwdriver, and then get the screws on this side of the fan, and the screws on this side of the fan remember to connect the screen line and not forget。
• at this point, you can connect the battery line, and then you can cover the back cover, as well as the back cover, which binds it together. When we're done, we'll twist the screws we just pulled off. That's it。
But we must be careful about the risks of dismantling the machines and be careful about the new players. Then go on, but be careful when the hood is removed and when the battery is pulled, otherwise the battery is more prone to error。
