I can't start
First, it is necessary to check whether the tide is caused by the rain of cars, etc., and if so, it is possible to dry it and then start it。
Second, check if the spark plug is damaged and, if damaged, replace the new plug。
Third, check the adequacy of battery voltage. Sometimes, when the lights are off and the lights are off, the power can run out. If this is the case, the vehicle can be activated by holding the vehicle in a second block, stepping off its foot, dragging it (generally not recommending, it would be preferable to have someone push it) and releasing it at a certain speed and twisting the ignition switch (generally not suggesting that the ignition switch should be opened before being pushed). If there were problems with generators, the law would not work。
Two, the steering wheel is shaking at high speed
Some of the reasons for the volatility, swinging and even twitching of cars at high speed or at a higher speed are as follows:
1. The forward locator angle is not correct and the front is too big。
2. There is an imbalance between the low air pressure of the former tyre or the start of the tyre due to repair, etc。
3. The number of pre-wheel irradiation or tyre bolts varies。
4. The installation of parts of the moving system is relaxed。
Five, bending, power imbalance, front-axis deformation。
6. Fault。
If there's nothing wrong with locating the bridge, let's do the tire balance
Four, on the way
Check the deviations, usually on the way, and set the wheel straight, and then release the wheel to see if the car goes straight. If you don't take a straight line, you'll miss。
The first run may be due to inconsistent pressure of the left and right tyres, which need to be inflated with less。
Second, it may be that the front wheel is not positioned. Angular angles outside the front wheel, main market angles or inner parts of the main market range, with front beams too small or negative to cause deviations and must be tested at a professional maintenance station
Five. Car lights are not sealed
Owing to the fact that the lights are not tightly sealed, water can easily be generated during cleaning and rain, and fog can be formed when internal and external temperatures are higher. At this point, it would be better not to bake at high temperatures, and the materials of the car lamp are generally plastic, and if the temperature is too high, it is likely to lead to a softer appearance of the car lamp, affecting its use and beauty. In addition, the lights are now generally integrated and transparent, followed by a backboard to protect the lamp, and high-temperature baking also causes the glue to melt between the two, increasing the likelihood of the lamp entering the water. In general, the water in a car lamp can evaporate quickly under the sunlight of the day, and if you have frequent water entry, you should check the lamp at the service station to see if it has been damaged by collisions。
