A fully automated washing machine has become one of the essential domestic appliances for cleaning clothes and sheets and preventing them from being cleaned because of lack of time or fatigue, which is a convenient means. In-service, no-water, no-dehydration, which is a common failure of a fully automated washing machine, the method of repairing a common failure of a fully automated washing machine is not easy, depending on the following analysis:
Common failure maintenance of fully automated washing machines: no water
1. Switch to the power supply, close the ears to the water valve, hear the sound of " buzzing " , check whether the pipe water is broken, first close the tap, jump out of the pipe and check whether the filter that enters the water valve is blocked with any alien; remove the filter and clean it if it is removed, and replace the valve if the problem is not resolved, it may be that the entry valve core is dead and cannot be opened。
2. If the water valve does not have a [buzz] sound, then try another method, such as replacing the computer board, the problem may be on the computer board。
Common failure maintenance of fully automated washing machines: no dehydration
First, the security switch is checked, the washing machine is connected to the power source to dehydrate, and the hand or tool is used to keep the safety switch to a minimum, and the security switch or computer plate is replaced if the computer plate alerts and the digital tube displays [e1]。
2. If the arm is braked by hand, or by means of a tool, the pressure is followed by normal dehydration, indicating that the break-off distance of the safety switch is already low, which requires the replacement of the security switch。
3. If, at the time of dehydration, only the wheel turns and the drum does not move, check that the tractor has separated the hysteria of the clutch from the turret, which, if not, may be the looseness and wear of the corrosive nut on the drain valve, resulting in insufficient distance opening and the need to adjust the distance of the calibration pole so that it separates the turret from the turret。
Common failure maintenance of fully automated washing machines: water in excess
1. The general situation is that the core of the water valve is stuck and it cannot be repositioned when the electricity is turned on, resulting in the flow of water and the direct replacement of the water valve。
2. If the failure is not resolved, the problem arises in the water table switch, which is used for a long period of time, and the water level switch ceases to enter the water and causes more than the water entry, and the water level switch shall be replaced。
3. If the pressure pipe is broken due to its length of use, wear or tear, or if the pressure pipe is not in good contact with the water table switch, or if the outer barrel air vents are removed, or if it causes leakage, it can also lead to water intrusion, with the master being searched and eventually repaired。
4. If the computer plate is not under pressure and the water level switch is not moving, it is misinterpreted to be more than water in the water table, then check whether the pressure pipe is worn, or whether the position at the two junction has been exposed, or has been removed; if so, the direct check is fixed to allow the washing machine to function properly。
5 when the pressure cannot reach the pressure switch because it may be blocked by an alien because of its length of use, then the large nut is to be twisted and the barrel is to be removed from the alien that is blocked。
With regard to maintenance methods for frequent failures of fully automated washing machines, as explained above, there are three common failures, read them first and understand them if they do not. An analysis of the contents of " how does the washing machine always fix the water? The full washing machine keeps the water repair steps " , which, by the way, can be useful. If you want to know more about your home, you should keep an eye on your family after the sale。
Reproduced for retention: http://www. Wanshifu. Com (teacher)
