With the rapid development of technology, printers have gradually moved into people's eyes, especially in office space. Of course, the printer will have to change its drums. But selenium drums are more expensive, especially for start-up small companies, and each time they are replaced is a little wasteful. So powdering the drums is a good solution. I'm not going to dwell on it, but i'm going to give you some details about the 388a peptide and pinky courses
A brief description of the 388a entropy drums
388a amphibian drums apply to hpp 1007/p1008 printers at an original loading price of $428 (price from network, for reference only)
388a simulets and powdered lessons
One, carefully remove the drum core and charge it
Two, then toss the screws on both sides of the scrape, remove the scrape, clean the powder
3. After cleaning up the waste powder, fix the scrapboard and fix the screws on both sides. Keep an eye on the sealed cotton mats on both sides, in case they leak powder
Four, remove the fixed screws on the right side of the chalk
Five, take two gears off the powdered silo, keep the big screwdrivers in place, remove the shaving boards from the silo, prepare to clean the silos and load them
Six, when the powder is cleared, the powder can be added. The pads can be replaced, and if there are no conditions, don't open them
I think you can do it!
Eight, cover up, watch out for spring. Yo, screw up, change the chip. It can be printed without a chip, but sometimes at a slower pace, clean up the table, and pack up the tools and finish the powdering process!
I've got a lot of attention
One, clean as much as you can of the carbon powder left in the drums, preferably with a vacuum cleaner or an air gun
2. Be careful to avoid injuries when cleaning critical parts of a herd (e. G., light drums, chargers, magnets) and use dustless / cloth cleaning
3 because of the very small size of the carbon powder particles, which are scattered in the air during the powder, protective measures are taken to protect mouths, nasal cavities (with masks and masks and rubber gloves, etc.)
4. Use high-quality carbon powder and do not mix it with other brands
5. All steps should preferably be handled by professionals using specialized tools
The above information on the 388a simulator and powdered courses and attention is more fully presented. From the above, we can see in general the steps of 388 americium drums to pollinate and draw attention. The powdering of selenium drums is a very cost-effective way of reducing the cost of small companies when they start, although it is only gradually being promoted under the state policy of encouraging university students to start their own businesses. Of course, there are problems that can be encountered when you pollinate yourself, and more attention must be paid to avoiding the problem of being inoperable when you pollinate. Then it'll be worth it。
