Mass santana dashboard failure light resolution, santana signal light chart large all
A complete description of the mass santana failure
Essentially, the indicators are divided into four categories:
A red sign represents a warning that the owner should check the failure before moving。
2 yellow indicator lamps represent an early warning function, but the corresponding issues need to be addressed in a timely manner。
3 the blue light advises the owner of the vehicle to be careful whether the long-light will affect other vehicles。
4 the green light is a functional light, e. G. A steering light, a broad light, a near light, etc。
The following is a description of the public santana indicators
4. Purge liquid level
The indicator light is activated, indicating that the glass water level is below standard and should be recharged in a timely manner。
Five, brake friction
This means that the friction is badly worn and ineffective. In order to prevent run-off during brakes, the same axle is usually replaced by wheel friction。
19. Turning to locking systems
The steering wheel was locked to death, suggesting that certain problems had arisen in the system. Therefore, not to pull vehicles at this time would inevitably cause accidents。
21. Tyre pneumatic pressure monitoring system
Tyres are too low or too high, and the dashboard will show the location of the tyre, and it may be that they have not been re-stored after replacement。
31. Electric mechanical stationing brakes
When the light is activated, the representative's handbrake is placed in place and it is automatically extinguished when it is dropped. The light continues to blink, indicating that the power is not sufficient to prevent vehicle movements。
32 battery storage
Batteries are too low or other failures。
48. Refrigeration systems
There may be a shortage of cooling fluids, or heat fans don't work。
Abs
The failure lights were activated, indicating that brakes were not effective at this time. In addition, the electronic differential lock eds failure and the failure light will be activated. At this point in time, vehicle brakes could be killed in an emergency situation, with the potential for side-sliding and tailing。
53. Fuel stocks
The symbol was first activated, representing about 8l of the fuel surplus. If there were problems with the fuel system, it would also cause a failure light to be activated。
57, engine oil levels
One is low pressure and the other is insufficient oil。
60, electronic car stabilization system (esp)
It blinks during normal working hours, often representing a malfunction. In addition, the esp will also be activated. The esp is primarily able to prevent extreme driving, side-sliding and tailings。
62, waste gas monitoring system
Reason: engine failure or problems with purification devices such as tri-chandeers。
Popular santana oxygen sensor failure light
The mass santana chanoxin sensor is installed on the engine exhaust. Aerobic sensors are key sensor components in the electrical jet engine control system and are key components for controlling vehicle tail gas emissions, reducing vehicle environmental pollution and improving the quality of fuel combustion of motors
How to judge the car's oxygen sensors are good and bad
1. Observation law
It's been released here before, mostly looking at the color of the oxygen sensor, judging the quality of the oxygen sensor, moving to the observation of the color of the oxygen sensor
2. Measuring resistance of oxygen sensors
Remove the sensor plug to measure whether the resistance of two of the wires is normal in the appropriate range (generally around 3 or 5 om)
3. Vehicle computer detector checks
Cars, hot cars, water temperature up to 80 degrees, and the voltage values of the computer detector oxygen sensors will change at 0v-1v, the faster the frequency, the better the sensors。
If the voltage is 0v or 1v, or if it does not change means that the sensor is old or not working well, replacement is required。
Photo of public signboard signboard light for the new santana instrument, flashlight/facility light for the new santana instrument
The most common and frequently used icons for the public's new santana dashboard are door tips, hand brake tips, seatbelt tips, engine self-checks, lubricating oil inspections, abs system checks, airbag checks, batteries alerts and fuel volume tips。
1. Seatbelt indicator light: is used to show whether the seatbelt is locked and, when the light is on, to indicate that the seatbelt is not fastened in time. Some cars have the appropriate tone. When the seat belt was fastened in time, the light automatically went out。
2. Car gate signlights: any door sign that is used to show the condition of the vehicle's doors, is not closed or is not closed, the signpost lights the corresponding door sign, the main door is not closed, and when the door is closed or closed, the corresponding door signlights are extinguished。
3. Oil indicator lamps: used to display pressure conditions for internal engine oil. The key door was opened, and when the vehicle began self-inspection, the signal light was lit and it went out after the start. The light was frequently activated, indicating that the vehicle's engine oil pressure was below the established standard and required maintenance。
4. Oil quantity indicator lamps: the fuel quantity light is used to indicate the amount of oil stored in the vehicle, and when the key door is open and the vehicle is self-inspected, it is lighted for a short period and then extinguished. If the light is lit after start-up, this means that the amount of oil in the vehicle is insufficient。
5. Abs light: used to show abs working conditions. When the key door is opened and the vehicle self-inspection is performed, the abs light will be lit for a few seconds and then extinguished. If it is not shining or if it is not extinguished after startup, it indicates that abs is malfunctioning。
6. Handbrake indicator light: used to show the state of the vehicle's handbrake, which is normally extinguished. When the handbrake is pulled up, the light is automatically lit. When the handbrake was dropped, the signal was automatically extinguished. Some of the models are accompanied by warning sound when the brakes are not down while driving。
7 water temperature indicator: the temperature used to show cooling fluids inside the engine, the key door is open, the vehicle is activated for a few seconds at the time of self-checking and is then extinguished. The water temperature indicator light is constantly on, indicating that the cooling fluid is above the prescribed temperature and must be suspended immediately. The water is out when the temperature is normal。
Brake plate light: used to show wear and tear on the brake. In general, the light is in a state of extinguishment and is activated when the brakes are malfunctioning or excessive wear。
Airbag indicator light: the airbag is used to show the working state of the airbag, which is automatically activated for a few seconds when the key door is opened and the vehicle starts self-checking, and if it is often lit, the airbag fails。
10, a bottle indicator: used to show the use status of the bottle. The key door was opened and the light was lit when the vehicle began self-checking. Auto-out after startup. The frequent lighting of a post-starter bottle indicates that the bottle has had problems with use and needs to be replaced。
What do you mean, mass santana dashboard failure
Volkswagen santana dashboardNic power coNtrol (full name engine electronic stabilization system), also known as the electronic gas-saving door。
The epc lights are more common in mass vehicles. When the key door was opened, the vehicle began self-checking, and the epc light was lit for seconds, which was then extinguished. If the vehicle does not go out after start-up, this indicates a failure of machinery and electronic systems. In general, there are two possibilities for the epc light. One is that the air-conservation door is dirty and should be cleaned. In another case, the brake light was not on and the brake switch and the circuit were checked。
And because of oil problems, the epc failure lights will also be lit. The general public's epc lights indicate that the vehicle is in trouble
General santana battery map, santana battery map
The failure lights of the popular old santana illustrate the following picture, identifying precisely the failure lights on the car dashboard, which are necessary for each driver. As the technology of the car is changing, it is no longer easy to accurately identify these abstract failure lights. The biggest car failure lights in history, hopefully, will help your owners. Seriously suggest a collection
The correct perception of the failure lights on the dashboard can help us reduce accidents or vehicle wear and tear, especially for those who don't know much about cars, and learn to learn.
