Self-check alert light for engines
The self-checking light on the engine is activated every time the vehicle is activated, indicating that the engine is undergoing self-checking。
Once the check is completed, if the engine does not fail, the icon will disappear and the entire self-checking process will be maintained for about a few seconds, indicating that the vehicle's engine is malfunctioning, preferably by going to 4s for further testing。
Oil pressure light
The oil pressure indicator lamp is used to indicate whether the oil pressure is normal. When the vehicle is activated, the oil pressure light will be lit. If the oil pressure is normal, the indicator light will then be extinguished and if it remains open, it will indicate an abnormal oil pressure on the vehicle。
Come on
The refuelling light reminds the driver of the vehicle to add fuel to the vehicle in a timely manner. When fuel is insufficient, the refuelling light is yellow; when fuel is extremely low, the refuelling light is red. However, some models are always yellow。
In general, when the refuelling indicator light is yellow, it is advisable to add fuel to the vehicle as soon as possible, rather than until the red light is activated. Because most of the gasoline pumps are currently required to be immersed in fuel for heat dispersion, the dissipation effect of the pumps could be significantly reduced if fuel is insufficient, thereby accelerating the damage to the pumps。
Water temperature light
Water temperature indicators are used to show the circulation temperature of cooling fluids in vehicle engines. When the vehicle is activated for self-inspection, the water temperature signal is activated and, if the water temperature is normal, it is automatically extinguished. If the start is not out, there will be two colour lights on:
1. A blue light is on indicating that the water is too low。
2. Red lights are on indicating excessive water temperature。
Abs light
The abs light is used to display the working state of the brake-capture system. When the vehicle is activated for self-checking, the abs light is activated, and if the abs system is normal, the start will be automatically extinguished。
If the abs light does not go out, it may be because:
1. Abs sensors have been damaged or obstructed by other articles. 2. An internal malfunction of the abs pump。
The abs light is often activated without prejudice to the normal movement of the vehicle, but the brakes are not useful at this time, and therefore the brakes should be avoided and repaired as quickly as possible。
Brake plate light
The brake plate light is used to show the condition of wear and tear on the brake plate and brake plate。
Normally, brakes are often lighted because:
Excessive wear and tear on brakes or brake plates, the need to replace brake blades with a lack of brake oil, and the addition or replacement of these lighting points represent a certain failure of the vehicle, but the fact that they are not seen to be too stressful does not mean that the vehicle will not be able to use them immediately, be careful to drive at speed or be able to drive slowly to the repair shop。
In addition, if engine failure lights remain on, there may also be a false failure. The so-called false malfunction is a display of vehicle failure, but it is working properly, which may have been an operation beyond the control of the computer and a failure code for computer feedback. We can remove any one of the car bottles and reconnect them in a few seconds。
