Use of branded iron
The iron is typically of two types, one internal and the other external. It is faster and more efficient; it is slower and less efficient。
20w inner heat
75w external heat
However, the general power of the internal heat pattern is small and the large power (over 50 w) is largely external。
In addition to the above, there's internal heat branded iron, which is placed outside the heater because it's a waste material and can only be bought if it's broken; and external heat branded iron, which is inserted inside the heater, which is broken (shortly unserviceable) and can be used to grind a fine, much larger section of the purple strip on the plug! And on the internet, all the fined copper bars (known as red copper) are now available (a much cheaper price than a special brandhead), and i have proven that brass can also be used, but not for good use。
Depending on the size of the welding points, different power levels of iron may be selected。
The first step in the use of iron branded (especially by beginners) is to hang the head of iron, which cannot be used without it! It seems to be a very simple thing at the moment, but when he first used the iron, it was the iron of the fire. It was a first step that he made. The saying goes, "no, no, no, no." not many people in those years have such a skill
The steps taken to hang iron heads are as follows:
1. Tie a new iron head with tin, provided that the iron head is of its own colour (purcot colour) and does not need to be dealt with, heat the iron, prepare a clean piece of wood or hard paper (with better fragrance) and rub it down on the side of the iron head that needs to be tined (with fragrance in the hollow)。
If welding is only welded and not welded, it is necessary to use cedars (even if they contain pine cedars, which are essential for welding), to put some fragrances on board or hard paper, and to crush the hot iron head on the welded cedar a few times。
Admittedly, welding is also good, and there is also a type of welding agent commonly known as bad water, namely, hydrochloric acid, which is highly corrosive, especially in bad water, and which is easily oxidized if the welding point is not handled in a clean manner. Except for welded iron, welded salvo or bad water is used as far as possible。
In some cases, a layer of plating is attached outside the inside heat iron branded head, which requires either an iron convulsion on the side that needs to be attached to tin or a grinding on sandpaper until the copper is exposed。
Because i've bought welded cedars, and they're in my article "a small commodity, reflecting the great times," and then i'll be bitten by a snake for 10 years
For the sake of safety, i bought one of these welders from hebei electronics company, a state company specializing in ishishi's estate
Because it's too thick to use, i melt and make it into such a thin piece
For the new iron head hanging process, please look at my video: video presentation: how to put new iron head hanging on。
