The precise source control primary mapping step 1, the mapping of road systems planning step 1) sets the mapping parameters. Sets the plot scale and font height using the drawing parameter settings command. Precise files are downloadable. Using commands such as " pline", "line" or "arc " , you can draw a central road line by entering a coordinate value and downloading a fine file. It is suggested that it would be preferable to use the pline multi-part command. Thanks for reading 3) generate a path. Using the " single-line circuit " command, select the road block form and width parameters, and click " ok " , the fine file is downloadable without fear, and then selects the centre line of the road drawn by step (b) in the chart, generating the road, repeating this step and turning all the road centres to the road. 4) sets the curve parameters for cross-cutting. Use the curve parameter settings command. Thank you for reading. Use “cross-treatment” or “single-crossing” commands. Thank you for reading 6. Automatic intersection processing may result in imperfection of certain intersections, and users appreciate reading. 7) broadening of the horn mouth. If the intersection needs to be handled by the horn, you can do the walk, or you can skip the reading. 8) generate coordinates. Use "road signs" - "all coordinates" command. Thank you for reading 9) generates road width signs. Use the "roadmark" - "all width" command. Thanks for reading 10) generates a curve radius. Use "roadmark" - "all radius" command. Precise files can be downloaded and edited. Using the "roadmarks" - "single marks" command, all roads are then given thanks for reading, and the fork's signs are up. 12. Generate road slopes, lengths and arrows. Use "road signs" - "all slopes" command. Precise files are downloadable. 13) marks road fault signs. Use the break sign command. 14) generate road fault maps. Use a " cross-blank " or " single-blank " command. Thanks for reading 15) insert drawing frames, graphmarks, signings, etc. Generates a grid using the insert frame command to thank you for reading 16. Generates the legend using the " generate coordinate map " command 17. Use the generate legend command. (18) deposit. For example, there are “road maps. Dwg”. 2. Planning step 1 for mapping control indicators) opens the map to be stored as an indicator map. For example, open "map. Dwg" to be saved as "indicator chart. Dwg". Thank you for reading 2) for setting the values for the default control indicators. Use the indicator setup setdef command. Thanks for reading 3) for generating control indicators. Generates all control indicator blocks using input indicator or generation indicator commands. Appreciate reading 4) if all indicator blocks are generated by the “generation indicators” command, the total area of land and the area of green land will have to be calculated. Thank you for reading the "total area" and "green land area" commands. 5) revise indicator blocks that do not meet the requirements. Use the indicator change command. Thank you for reading
