Methods for improving the pass rate in subject one
1. Theoretical importance
Focusing on theoretical learning is the first step in driving a driving licence and taking it seriously is responsible both for itself and for the lives of others。
2. Model tests
It is important not to think that the repository is finished and that the examination is ready for examination, but also that several more mock tests are required before the examination to fill the gaps, and that the examination process for familiarizing itself with the actual examination in subject i with the test is operational and effective in alleviating pre-test pressure。
Two or five mandatory tests
I. Back into the garage
1. Hang up slowly into the examination area and maintain a distance of 1. 5 metres from the edge. (b) stop when wheeled over the yellow line
(b) step on the entanglement, hang the reverse block, slowly retreat the vehicle, observe the left rear-view mirror, and quickly kill him in the right direction when the rear-view mirror is reconnected with the edge
3. Upon completion of the direction, the line of sight is immediately transferred to the right rear-view mirror to observe the distance between the right back wheel and the corner of the garage. If it is less than 30 cm, go back in half to one direction; if it is greater than 30 cm, it cannot be adjusted and the line must be pressed
When the body parallels the garage line, it returns to the directional wheel. If the body is not right, fine-tuning is required, and any wide direction is required
Parking when the rear vision mirrors overlap with the boundary line
When out of the garage, look at the right rear-view mirror, the right back wheel can shoot you in the direction。
Ii. Targeted parking and start-up of ramps
1. Uphill the body of the car and maintain a one-third reconnection of the side line on the right side of the head, at a distance of approximately 30 cm
2. A slightly higher degree of convergence during the upper slope to prevent the fire from going out
3. Left rear-vision mirrors, when the rear-vision mirrors are reconnected with the positioning line, step on the disconnection and brake and stop
4. The left turn light, the right foot, the brakes, the left foot, the cleavage, until the semi-alignment state, the clutches, the right foot, the brakes slowly, the car starts, and when it stabilizes, it is all loose。
Iii. Turning right in the north
1. Reposition the body before entering the examination area and maintain a third of the right side of the head of the car to re-engage with the outer side line, which is approximately 30 cm
2. Drive at even speed, killing the person in the direction of the door when the inside of the door coincided with the corner。
Iv. Side parking
1. When entering the examination area, the vehicle remains 30 cm from the right line. (b) stop the vehicle upon arrival at the designated position
2. Hanging back, stepping on the clutch, moving back slowly, observing the right rear-view mirror, and killing him right quickly when he does not see the upper left corner of the library
3. Observe the left rear-view mirror and return in the right direction as soon as you see the lower right corner of the library
4. When the rear left wheel is about to press the line, it is quickly shot left. The car will be parked when it is fully in the garage
Turn left to light, shoot left, observe left rear-view mirrors, and point right when the wheel crushes the line。
V. Curve travel
When entering the examination area, the header is directed to the middle of the entrance to the s bend. Keep an eye on the rear-view mirror. Watch your speed。
Operational steps for the third compulsory examination
1. Preparation of examinations
1 out of the rear left of the examination car
2 counterclockwise from tail to driving position
3. Confirm safety, open doors and enter the driver's seat
4 seatbelts, seat adjustment, rear-view mirrors
5 view dashboards and light switches
6 report to the examiner that the examination may commence。
2. Light simulation
Start the car
(b) the hearing of voice-pointing light simulation tests and the opening of the overall light switch
(a) the light operation is completed within five seconds of the completion of each instruction
The lights are over. Turn off all the lights。
3. Start
(a) interposition and brake
1 block of 2
3 left turn light (over 3 seconds)
4 horns
5 break the brakes
6 lifting off
Confirm the safety of traffic around them
Eight loose brakes, start。
Four, straight
Maintenance of a straight line at the driveway centre
The two wheels need fine-tuning
3 vehicles at 30 km/h-35 km/h
Special sections or road conditions are encountered and pre-empted。
Five, 100 meters plus reduction
One before entering the examination, slowing down the block to one block
(b) block 2: light-step the oil door, speed it up to the speed zone of the switch, and break it down and switch it
Blocking: light brakes, slow to the speed zone of the switch, stomping off and switching。
6. Change of lanes
(a) one to turn light (more than 3 seconds)
(b) observation of rear-vision mirrors and observation of traffic around them
3 upon confirmation of safety, direct
When the head of the vehicle turns through the sign line at the centre of the road, the light turns off
Change to target lane, heading back。
Seven, turn
One early slowdown
2 turning lights (over 3 seconds)
3. Observation of traffic around them
4 upon confirmation of safety, direct
Turn five to target lane, back in the right direction。
Turn around
One early deceleration and one block reduction
2 left turn light (over 3 seconds)
3 observation of left rear-view mirrors and traffic around them
4 killed to the left after confirming safety
Five into the target lane and slowly back in the right direction。
9. Pull over
One early deceleration and one block reduction
2 right turn light (over 3 seconds)
3 for rear view mirrors to observe traffic around them
4 upon confirmation of safety, right direction
Five headers crossed the line and turned the light off
Control the car around 30 cm from the side of the road and reverse it
7 brakes
Eight entanglements, blindfolds, hand brakes
After the examination was confirmed, the seat belt was removed, the rear vision mirror was observed, and once it was confirmed safe, the door was opened and the door closed。
Subject iv examinations attention
1. Carefully consider the subject and look at the keyword. Like, "right is wrong is wrong." don't look away。
2. Order of answer. Sometimes, while the subject matter is the same, the order of options for the answers may be adjusted, and it is important to be careful at the examination。
3. The examination is time-consuming and does not rush into the matter, and it must be repeated once it has been confirmed. Multiple selections need to look carefully at the options and filter each to prevent leakage。
Click on a blue word above
