Like this piped drain。
Heat-type accelerants must not be able to detach the kitchen pipes. Some decompressants are easily burned when the temperature is high. The client was misusing it and burned the sewer. Don't you usually cook? Not much? If you're burning less, you're going to use a decompressor and you're going to burn。
If the pipes in the washhouse are blocked and the water is slow, it is only possible to remove the clogged pipes and to remove them or to untangle them. If you don't want to tear down the pipes, it's better to burn the canteens and flush them into the pipes than tonics. Because some of the product formulations of the defunct agents are hot, many customers pour themselves into the pipe with heat-type defunct agents, sometimes deforming the sewers and flaring them, easily causing leaks。
The client i don't know about the decompressant he bought, he burned the pipe. It is difficult to match pipes that are usually burned because many of the components in the sewers are not of the same type. It would be better to replace a drain in a kitchen such as this because the interface is stable and leaks are not easy。
Some of the owners tried to save money and buy a single tube that they could not buy for five or six times in a hardware store. I personally suggest that the sewers be broken and that they be replaced. The replacement of the sewers was simple, but it would be difficult to burn the pipes temporarily。
It is also simple to install such sewers, and if followed sequentially, every nut has a ring inside, and if it is tightened, there will be no leakage. Without changing the kitchen drains, the usual spills, like his, do not need to be replaced, but the pipes are undisturbed and broken. So the new pipe spills have to be installed。
There's a cortex at the spill, and there's a plume, and it's stuck on it. That's it. And then screw the middle screw down. The old spill pipe is now removed with an electric screwdriver. Just throw it away。
• load new spills to the back of the drain, and fix them with a fixed screw to the sink vent。
• the next step should be to put the spill pipe on the drain. The drains are not in the right direction, and the caps are plugged from the right to the left, and the spills are brought to the right。
For example, it is easier to install sewers as long as they are bought and loaded with instructions. The sewer fittings were also fitted with a water purification vent, which was sweet. Each set of pipes is equipped with such an interface, which is either available or not, and is largely not useful。
This is the whole one-train pipe. It's a bit of a problem with a double-train. The pipes are closed, the needles on the roof of the customer's washroom are opened, and the sewers below are checked for leaks. It's nice and sweet to add a reeking drain valve to the sewer. When the water flows, the drain valves open, and if the water stops, the deodorant valves close。
Cover the sink with a plug, wait for more water in the pool and test the sewers later. It's almost empty. Open the drain cap. Look at the interface below. It's pretty fast. The sewers like this can be blocked for a long time and can be removed and cleaned separately。
