Flower y5-51 large centrifuge, g5-51, y5-51 no8-29. 5d boiler centrifuge, windmaker
The high-pressure head performance parameters of the fluidized boiler are also met by means of the application of the type g5-51, y5-51 boiler to the ventilation system of the 2-670t/h steam boiler in the fire power plant. The series is also used for dust removal, mine ventilation and general ventilation systems。
Wind transmitters deliver air, wind transmitters transport gas containing flue gas or impurities particles. The impurity depth is less than 4 years at 200 mg/m3. Large impurities may also be used, but the useful life will be reduced. The maximum temperature to be used in the delivery, wind-leader shall not exceed 250°c。
2. Wind-leader y5-51 large centrifuge, form
1) wind transmitters, wind-leading mechanisms in a single form. Unit no. 8-29. 5 has 40 specifications for 20 units each。
2) each wind machine can be converted into a left or right rotation。
3) wind engine position, expressed in terms of export of the shell。
4) the wind vehicle is operated in type d (i. E., a hearing structure) and the electric motor is connected to the wind engine by an elastic axis, which is directly connected。
5) examples of full names of products are as follows:
G5-51-1 no18d 90 degrees right
Y5-51-1no18d 0 degrees left
Of which: g and y, respectively, indicate a boiler and boiler engine,5 a pressure factor of 10 times the maximum efficiency point,51 a velocity,1 a first design, and no. 18, a leaf wheel diameter of 1800 mm。
3. Structural characteristics
1) the wind machine in this series uses proprietary technical results such as high-intensity leaf grinding vessels, leakproof bearings, joint axle bearings, etc。
2) the range of high-efficiency work is wide and the wind engine numbers are well organized, making it easier to select high-efficiency work points。
3) use truncable vents. This means adjusting the axle direction and trajectories of wind vents and leaf wheels at the time of installation。
4) high-intensity grinding wheel. The use of backward single-leaf blades to reduce the impact of air currents, which are stable and less susceptible to overloading of electric motors, significantly increases the lifetime of wind machines. The wind engine has a high pressure factor, low weekly speed and low noise, which makes it useful。
5) leakproof bearings. A half-opened aluminum oil seal, in addition to facilitating repairs and preventing frictions, can be used to increase resistance along the axes to divert some of the thin oil back to the tank; the outer plate root is to block a small amount of thin oil; and the upper end of the bearing is to reduce the slight positive pressure in the bearings, ensuring that the oil is not leaked and that the dust is good。
6) the joint axle to the control door. The control doors are equipped with noxious bearings and no “dead” points in the operation and reconciliation process, thus allowing flexibility and reliability to be reconciled and the enforcement agency to be installed。
7) the wind transmitter y5-51 is a large centrifuge, which is assembled in a whole or in a fraction. The transmission group, co-axis, electric motors under 16d of the series are assembled on a complete base before the plant is discharged; the shell, vent and control doors are another component, the mini-winder is assembled on its departure in two components, and the large-scale decomposition is assembled in multiple components for transport and installation。
8) the wind machine is a height structure, easy to install, electric motors are connected directly, the rectangular is evenly passed, and the vibration is reduced to make the wind machine work。
9) the installation and repair of the wind machine is convenient. The wind machine has two complete sub-seasonal zen and transvestite units, with medium or vertical sides of the shell, which are particularly convenient for dismantling, and rotors can be suspended vertically, or axle-directed when the wheel is replaced。
