Hello, welcome toPeanut Shell Foreign Trade Network B2B Free Information Publishing Platform!
18951535724
  • How do you change the oop's

       2026-05-19 NetworkingName790
    Key Point:During the use of domestic electricity, damage is inevitable and requires repair. If they had the relevant knowledge, they would not have to hire maintenance workers to spend time and effort. Here's how the opp battery lights can be changed so that when the buffalo lights are broken, they can be changed and quickly。The shower bulbFirst, cut the power and take off the heating lights on both sides. You can see two clinkers on the side of the

    During the use of domestic electricity, damage is inevitable and requires repair. If they had the relevant knowledge, they would not have to hire maintenance workers to spend time and effort. Here's how the opp battery lights can be changed so that when the buffalo lights are broken, they can be changed and quickly。

    The shower bulb

    First, cut the power and take off the heating lights on both sides. You can see two clinkers on the side of the heating light position, and then you can take off the whole tuber plastic cover after the clinker is removed, and you can see the light. When you see a light, you'll just have to rip off the light bulb and put it back on。

    It combines a combination of bathroom heating, infrared physiotherapy, bathroom respiration, daily lighting, decorating, and so on with a combination of bathing small household electrical products. At present, ablutions are generally divided into ablutions in the light bulb series; ablutions in the ptc series (a ceramic thermal component); and ablution in the double-heating series。

    The light bulbs used in the tuba are special and cannot be changed, because the bulbs used in the tuba are blastproof. Lights are usually 40w. Just go to the light shop and buy a special light bulb, and be patient when changing it, because when you install a bath-bust, you put the hooks on the panel and then screw the light bulb, so you can change the light bulbs and just screw the light bulb. When wringing, hands are dry, no water or sweat, and remember to cut the power before changing the light bulb。

    There are a number of possibilities for ablution bulbs: a. Has poor contact with the light, b. Has been tightened, c. Modems have been broken, and currents have been replaced. This is for maintenance) d. Circuit failure and repair of the circuit (this is for maintenance)。

    Having seen the above presentation, we believe that we all know how opal lights are changed so that we can solve this problem immediately. However, it is important to exercise vigilance and, if less familiar with this aspect, to proceed strictly in accordance with the replacement step and to avoid danger. I wish you all a good life

     
    ReportFavorite 0Tip 0Comment 0
    >Related Comments
    No comments yet, be the first to comment
    >SimilarEncyclopedia
    Featured Images
    RecommendedEncyclopedia