How do you clean air conditioning without a specialized tool for high pressure water guns? Now i'm here to share it with you, and it's clean to do it。
Like cleaning air conditioning. First, pull the plug and put some paper under the air conditioner to prevent dust. Then we'll tear the shell, pull it on both sides and lift it up。
And then take off the steering board. It's a card button. It's dirty。
And then take off the decorator caps of the shells, which are screwdrivers, and take all of these screws off with a crane or screwdriver。
Take off the filter again, and then you can take off the whole shell. There's also a connection that shows the screen receiver, which is to be removed and opened。
Take off the pilot leaves and just pull it out. It's all stuck here. There's two。
Now we can do the cleaning. First, clean up the dust on the evaporation machine with a rag, then spray the air-conditioning scrubber on the evaporation device, which is sold in a place like this。
• then brushing the windmill inside with a little brush, which is dirty, so brushing straight back and forth. The wind wheel is done. Clean up the dust with a wet rag。
The interior air conditioner is cleaned up, the evaporation unit is also available and the interior is cleaned up。
And then wash the shell. First, the receiving board and the display board were removed, then taken to the bathroom and washed, and then wiped all the water from the shell with a rag。
• the air conditioners will be fully cleaned。
· then plug it in, the ac opens up the cooling mode, lowers the temperature and allows the ac to run for several minutes。
- get the fresh spray out of it, that's all。
The air conditioning is done. It's clean。
