In many cases, the microwave magnetic tube is broken and the replacement of a new one, which is in fact a significant part, can be repaired, and is fully recoverable if the magnetic tube light is plugged in and short-circuited. If the magnetic tube is not aging, the light-wire resistance value for measuring the magnetic tube should be less than 1 om. More than two om is aging, with no repair value, and even if the heating is repaired, it is not good. A pistol drill drill drilled the four punctures fixed to the interpolation, then opened the end of the top with a single-word screwdriver, broke the light wire sensor and the interpolation connection with a pointy piston, fixed the new interpolation and welded it with air. Of course, welding can also be done with high-power branded iron, but the light is working with large currents and the heat cannot be underestimated. I'm welded for safety. Actually, welding is not so hard. The following figure details the process of repairing the magnetic tube. I would like to give you some information。
The replacement magnetic conduit has worked well. The following is the process:
1. A soft start cap with a single-word screwdriver and plier. You can't break it with a screwdriver.
2. Be light, not deformed, so that recovery is not easy. Upon recovery, the end covers will be placed to the same level, with a small stroke of a plier。
3. The failure of the microwave magnetic control tube in the short circuit was typically punctured between the light-wire plug and the shell. The plug will be replaced and repaired. (the ageing of the magnetic tube can't be repaired and can't be repaired)
5. Welding of lights and plugs with air and silver bars. This step is important! It's a magnetic tube to replace the plugs and weld the light. In the case of new welding, it is possible to surround the perimeter with toilet paper, soaking water and then welding。
Welded with a medium fire at speed. Otherwise, it's easy to melt the plugs to the end。
7. The magnetic controls of the plugs were replaced, and welded images were present at the bottom of the article。
8. Repaired magnetic tubes. There's no difference between performance and new. It's first-rate heating
If the tube is burned, it will be sufficient to remove the antenna hat of the tube with a small tiger torque and replace the new antenna hat. In general, microwaves are burned as a result of the oil contamination inside the microwave, which has caused the microwave to be reflected in the mouth of the wave catheter。
I hope it helps you
Keyword: microwave magnetic conduit restoration and reuse of microwave conduit
©2023 wiku electronic market network (www. Dzsc. Com) filing number: zheb2-20050339-1 operating licence: zheb2-20200386 copyright declaration
Buyer service line: 0571-85317607
Seller service line: 0571-85317607
©2023 wiku electronic market network (www. Dzsc. Com) filing number: zheb2-20050339-1 operating licence: zheb2-20200386 copyright declaration
Buyer service line: 0571-85317607
Seller service line: 0571-85317607
