The smoker is a good mother's helper, and the use of the smoker when we cook and cook not only benefits people's health, but also protects their environment from the smoke。
So, what about the smoker? How
The purchase of a new house must be accompanied by the acquisition of furniture and electrical appliances, and the smoker must be one of the first appliances to be selected, since the smoker is one of the most common domestic appliances in family life today, mainly for the purpose of cleaning up the kitchen environment。
However, you may have to pay high maintenance costs and endure smoke harassment. But don't worry, this will tell you all the knowledge you need to repair your own smoker。
1. By functional switch, nothing。
This failure is due to different power sources。
2. Automatic control failure and non-lighting。
This failure was due mostly to a lack of cleaning maintenance and the oil contamination on the surface of the sensitive sensor installed on the panel, which caused the sensor to suffer. Remove the aero-sensitive sensors and wash them with a brush in the detergent. If there is dirt on the surface of the sensitive head, it can be filled back to its original location with waterless alcohol and failure is eliminated. If this is not possible, it is sufficient to increase sensitivity by regulating the sensitive bits in the circuits, and to replace the bits if they are still ineffective, most of which are damaged. None of the repairs described above have been performed, but the aero-sensitive sensors have lapsed, new items have been replaced and the failure has been eliminated。
3. Press the key switch and do not turn while the engine turns。
This failure was caused mostly by:
One is the transformation of the tentacles by the key switch, resulting in the immediate departure of the motion point. Washing the tentacles with a cleaning agent, then remediating the root of the tentacles with a sharp-sniffed plier and restoring flexibility to allow normal contact at the motion point。
The second is the poor contact with the loose conductor of the electrical connector to find the loose screws to be re-healed。
Thirdly, the electrical wires are loose, the mains are loose, re-established, welded, if necessary, and wrapped in insulation。
4. The motor is either difficult or inoperable。
Most of this failure was due to a failure or failure of the electrical power capacity。
The electric power is spinning, the noise is high and the shell is hot。
Most of this failure is due to a severe oil shortage or wear in the electrical rotor bearings, beginning with the removal of the leaves and the slight shaking of the rotor axis with the hand, at which point two phenomena occur:
The first is that there is no loose movement and that there is a severe shortage of oil
Second, there is a relaxation and a wide gap in the hand, which is a severe wear and tear of the bearings and requires the replacement of new bearings。
