I. What if the mop can't spin
Rotating mops are a new type of mop, consisting of a mop itself and a mop drum, which can be rotated for cleaning and dehydration and ease of use. In the case of rotation mops, which may sometimes be unable to rotate because of various malfunctions, the following approach could be taken: one, reverse the rotation mop, drop lubricating oil at the entry point of the moping and stretching, then drop a circle outside the pole, allowing the lubricating oil to slide slowly into the inside and then rotate several dragsticks. 2. Flatten the mop pole and rotate it several times, so that the internal parts are evenly oiled. 3. Discrete the upper end of the mop pole and drop some lubricating oil from the open entrance. 4. When refuelling is complete, multiple turn mops allow the components to absorb the oil evenly and feel flexible enough! If not, repeat the above steps until flexibility is used. There are a large number of rotation mops on the market, and it is easy for some poor-quality products to be rotated for a short time, and it is suggested that, in the selection process, you select products with a high-quality rotation mop brand。
Ii. How to replace the mop head with a rotating mop
In order to clean up the tools, it is necessary to replace the mop head periodically by: (1) flattening the mop on the floor, stepping on the mop with the right foot (as close as possible to the metal part), holding the mop pole in the left hand, rotating the bottom of the counter-clockwise, hearing the sound of the card, and separating the handle and head. 2. Throw away the old mop head and wash the rod with a wire ball and wash it with fresh water. 3. The new mop head is ready, flat on the ground, pointed the handle to the centre of the head, rotated the clockwise, and installed once the sound was heard. 4. Lift up the rotating mops to check whether the mop head and the pole match and can be used properly without cracks. In normal use, it may be replaced every two to three months, not more than half a year。
Iii. How to use the spinning mop
1. Newly purchased rotation mops need to be assembled, assembled and placed vertically in the toilet wash box, moved gently up and down to wash the cloth, when cleaned, placed the mop in the dewatering drum, slipped the switch down, kept the moping pole and the dewatering sink vertically, applied lightly upward and downward pressure, then accelerated by about 3-6 times. 2. After the dehydration tank is completely static, adjust the mop pole to the appropriate height, lock the switch to the top and then press down the pole and start dragging the ground. 3 when ground is towed, the rotation mop can be rotated, its head is soft, and it can be condensed and deformated, so that the rotation mop can go deep into some tiny cracks to clean; and the rotation mop can also use its ability to rotate features to clean the dust on the ground using 360° tow. 5. After the use of the rotating mop, the mop will be placed in the mop drum, the mop will be twitched and cleaned on the sink, then dehydrated and placed in the ventilated area, pending its complete drying, before the upper and lower stretch of the mop pole is partially recovered, shortened, then placed in a cool position, for next use。
Iv. How to install a rotating mop
1. The purchase of rotary mops is preceded by an inspection of the completeness of the accessories. 2. When assembled, a mop pole is assembled, the pole is divided into a fixed pole and a stretcher pole, and when installed, the fixed pole is inserted to the stretcher pole, and it is tightened when a "card" is heard. 3 then the towpad is installed, the towpad is placed on the flat ground, the stretchbar is aimed at the insertion of the towpa, and the wheel is tight. 4. Lastly install a mop head, which will be directed to the mop head, the tip of the mop head and the mop, and then press down vertically, tot-toe the mop, and make a condensed sound。
