How can we deal with the situation when we have a pot of electric water, which is easier to live with, when we want to drink, when we don't have to put it in an open bottle, if we want to drink as much as we want, if we don't waste it. The following mini-codile presents some of the methods used to repair the electric kettle。
If the power switch is normal, most of the failure occurs at the temperature protection switch. First, see if the two-metal tablets are pressurized on the switch handle, and if overstretched, they can be bended upwards with a slab until they are between 0. 5 and 1 mm. If the distance between the two-metal piece and the switch handle is normal, the switch box should be removed and the contact points and springs of the maintenance of the thermostats removed。
The instruction light is activated, indicating that the power supply has been added to the indicator light circuit, that the failure is in the electrical thermal tube or its connection, and that the common electrothermal tube is damaged and poorly exposed. Dismantling electro-thermal tubes to measure the resistance can be judged. The electrical thermal tubes are damaged and can normally only be replaced. Poor exposure is mainly due to severe corrosive or deformed contact reeds in power plugs, which can be removed from the switch box to clean and repair, and the damage is best replaced by serious damage。
If the reset switch fails. The common cause is the severe disfigurement of the sensor tablets or the disruption of the switch pole movement. For the former, the concussion of the concussion angle of the little tongue of the thermostat allows it to drive the switch pole properly. For the latter, it is necessary to identify the blocked or alien, which generally can return to normal with the removal and correction of the alien。
Common causes are low power voltage and poor exposure to indoor power lines or plugs, which should be excluded first. The electrical thermal tube is then checked for serious accumulation, exposure between the base and the kettle power plug, etc. If the electro-thermal tube is muddled, it can be scraped with a knife and then polished with sandpaper. If contact between the base and the pot's power plug is severely poor, the plug exposure table and contact oxidation layer, stains can be removed and the shape corrected to make the contact close and good。
These are the four methods of repairing the electro-heat kettle, described by the young editor. As you can see, the proper method of repairing the kettle is to be chosen for the different reasons for the failure of the kettle. The problem with the failure of the general canteen is not so great that we can do it ourselves, and in case of failure that cannot be repaired by ourselves, we can do it without a license。
