Today, the electric kettle is a small household electricity that is essential for the well-being of people and is therefore very popular. Formally, failure is inevitable because of the high frequency with which the pots are used and work at high temperatures. And how does the kettle temperature sensor work? This is followed by a mini-editor to show you how the temperature sensors of the electric kettle are maintained。
I. Electricity after boiling water
The constant electricity after the boiling water is usually caused by the failure of the reposition switch. The common cause is the severe disfigurement of the thermostats or the disruption of the switch poles, for example, so that they can bend the condensed angle of the thermostats so that they can drive the switch poles in a normal way, and the blocking of the switch poles requires the identification of the blocked parts or foreign objects, which generally can return to normal by removing the alien and correcting positions。
Ii. Slow heating
The slow pace of heating is generally due to low power voltage, poor exposure to indoor power lines or plugs, examination of whether the electro-thermal tube is severely saturated, or poor contact between the base and the kettle power plugs. If the electro-thermal tube is muddled, it can be scraped with a knife and then polished with sandpaper。
Iii. Electronics delivery
The drying of the kettle was mainly the result of the failure of the thermostat. It is possible to check whether a bimetal piece is deformed or loose, if it is deformed, it can be re-corrected with a pointy plier, and the spacing between the bimetal piece and the switch trigger should be 0. 5-1 mm, and if it is loose, just tighten its fixed screw。
Iv. Non-heat after electrical power but signal lights
The fact that the power is not hot but the light is on indicates that the power supply has been added to the signal light circuit, that the failure is in the electrical thermal tube or part of its connection, and that the common electrical thermal tube is damaged and poorly exposed. The electrical thermal tubes are damaged and can normally only be replaced. Poor exposure is mainly due to severe corrosive or deforming of the contact reed in the power plug component and severe damage to new ones。
This is the description of how the thermosens of the electric kettle are being repaired, and it is hoped that it will help you!
