Smart canteens are our usual home appliances, but after some time of use, there are a lot of accidents with smart canteens, some of which break fuses, some of which show signs that the lights are not on, some of which even fail, or if the power is not cut automatically after the water turns on, which means that smart canteens are broken and need to be repaired。
In general, the thermostats of the electric kettle are basically sld thermostats, slt thermostats, jiatai thermostats, and if the heat kettle is not hot, the same product can be found to replace it. If the electro-heat kettle is unheated, the failure takes into account what materials the electro-heat kettle is, and in the case of plastic kettles, it is generally possible to replace the heater directly; however, if the stainless steel kettle is used, it is estimated that the electric hot kettle will end up in its whole body。
Since stainless steel-body heaters are welded, there is no way to replace them, the stainless steel kettle heaters and some parts of the kettle are not the same for each manufacturer's molds, so if problems arise with the electric kettle, they should be repaired directly back to the plant and, when it is recommended that hot water kettles be purchased, care should be taken to purchase products produced by well-known manufacturers, which can be easily repaired。
1. The signal light is not on and cannot be boiled. Check for voltage input, if not, for power plugs; if there is voltage, test for heat tubes。
Boiling noises or automatic power outages when the temperature has not reached the standard, boiling or protective, possibly temperature control damage, should be repaired and, if not, replaced。
2. A leak in the kettle? A, failure of the heater tube, resulting in a leak;b, a leak caused by loose internal connection;c, a leak caused by water leaking inside the kettle。
3. The constant electricity after the boiling of the water is mainly due to the failure of the re-entry switch, usually due to severe disfigurement of the thermometer or the disruption of the switch pole. For the former, the convulsion of the convulsion angle of the little tongue of the thermostat is sufficient to enable it to drive the switch pole properly. For the latter, it is necessary to identify the blocked or alien, which generally can return to normal with the removal and correction of the alien。
4. Reasons for the increase in the length of water burning? The main reasons are related to environmental conditions, the amount of mud in the electric kettle and the low voltage. Thus, during the course of use, the excessive amount of time spent on burning water without the three above-mentioned conditions is generally not a matter of the quality of the pot itself。
These are the methods of repairing the smart kettles, which, in the case of maintenance, must be matched with the cause of the damage, and then drugged, so that the hot kettles can be repaired quickly and, to some extent, the damage to the kettles and the usage habits are closely linked。
