Today we have a detailed description of the method of installation and use of toyota's vehicular radar:
First of all, you need to prepare a set of reverse radars, an open drill, a rope, a plastic disassembly bar, a wrench, insulation tape, a bandage, an electric pen or, at the minimum, a screwdriver, a drill and fine paper。
Before you start installation, please remove the warm cotton on the left side of the trunk. When wiring is done, the tape by the driver's door is pulled as soon as it is routed from behind. There's three slots in the tape, and the middle is stuck to the door frame, and we're going to go to the right, the inside。
Next, deal with the pedal at the driver's seat. It's easy to take it from inside, without tools. After being removed, radar cables were worn in the cards along with the original vehicle line, and the ropes were strangulated to avoid sound. More rope to ensure stability。
Here in pillar b, it can be plugged in with a detachment rod from the gap in the floor and through barbed wire from the front to the back, so that there is no need for a little plug。
After crossing, the back seat, under the pedal and the front, was held together with a rope. Lift up the back seat and make it easy to pass. Wiring through the gap of the lock of the trunk door does not damage the interior。
Next, connect the power. The big white interface is the head of the rear light. On the other side of the junction, there's a cardhead, which can easily be pulled off with an electric pen or a little screwdriver. Don't pull it。
In order to be able to maintain a no-lose connection, the radar power orthodox line can be made into a specific head and then inserted in the reverse light. A negative polar line is attached to iron and can be attached to the rear light of the lock on the trunk door。
Mark the opening position, protect the bumper with fine paper and avoid scratching. Use of a drill to start drilling and to see if there is power around it。
Connecting the probe with the transmission line makes it easier to cross the line. Mark the mainframe interface of the four probes to avoid error. When installed, look up and have arrows so that they can scan down。
When the probe is secured, it is protected by rubber dust cover. The probe is drawn out of the rubber dust cover and can reach the entrance directly below the bumper. All four lines were introduced, entangled with insulation tape, attached to the mainframe and glued to the sideboard of the trunk with 3m glue。
Finally, the car was set on fire, placed in reverse and measured to see if the reverse radar was working. In general, the cost of vita vita added the reverse radar is about $320 or $500 if it is better. Installation costs are generally around $100, depending on the region。
The main function of the reverse radar is to use the ultrasound principle to send ultrasounds using a probe on the end bumper, to reflect back after impacting the barrier, to calculate the distance between the body and the barrier, and then to inform the driver about the barrier around the driver by means of sound or more visual displays, to help the driver to be more secure in the vehicle, to reverse it and to start the vehicle。
The type of vehicle that toyota via is currently selling is 2022, which was listed on 13 july 2022. In the light of the previous change in via, the new via is a medium-term change, which is expected to be released in july 2024. Medium-term modifications would not normally be based on a new look design, and the interior features would remain essentially as they were. The new edict may optimize and upgrade its configuration and functionality to meet consumer needs。
