The electric sewing machine is a good helper in our lives, making our lives a lot easier. But since it's a machine, it's always a problem, like a wire break, which is one of the common problems of electric sewing machines. Today we will explore the reasons for the break in the electric sewing machine and how to fix it, so that we can use it better。
'cause the electric sewing machine's offline
There are many reasons for the breakdown of the electric sewing machine, mainly with fault lines and face lines, the most common being the following:
1 if the line is not fixed, the line will be cut off. Solutions: the best way to switch lines is to delineate them first, which should be when the core is inside the clamp, with the line in its hand, slowly down to the bottom, and then rewire them on the bottom line。
2. If the pressure is not fixed, the line will be cut off. Solutions: pressions on the edges of the foot and needles when the foot is pressed, and shakes the hand to the right and the left when the foot is pressed to see if the needles are touched。
3. Breaks between the pedals and needles. Solutions: the distance between a shuttle hook and a needle sink should be 0. 1 mm, and less than 0. 1 mm is easily broken。
The fabric is too thick to break the wire. Solutions: tighten the screws above the top of the foot and put some pressure on it。
The fabric is too thin to be wired. Solution: feet when sewn out the fabric line。
Six, needle rods and shuttle beds are disconnected without synchronization. Solutions: the needles are placed on the tablet when they are fixed, and the needles are just moved to the height of a shuttle and then to the bed。
7. The needle hole is too sharp to be wired. Solutions: a round needle is recommended, albeit at a more expensive price。
The power sewing machine needs attention
1. When necessary, cover the aircraft with a cloth or a hood so as not to fall into dust.
2. The main parts, e. G., elastic, elastic, etc., are used in a rustproof manner.
3. When the empty car exercises, the pressure should be raised so as not to wear the teeth and the floor of the pressure.
4. Leakbeds are the easiest to accumulate, such as wires and crumbs, and affect the normal rotation of the machine. For each short period of time used, the leatherbed should be removed and wiped out, and then put on it. Be careful that it is properly fitted and plain, so that the needles are not broken while using the machine.
5. Protect the fabric, wires or other things from the belt, preventing the machine from moving normally.
6. When refuelling, in addition to the injections by each hole, refuelling the internal operation of the machine.
The needles on the sewing machine are most easily rusty, and can be made into a little sack of cotton or lime powder, and then put the needles in a little bag, and then put them deeper, then pull them out, so they don't rust, and it's smooth.
Editor-in-chief: i'm sure you're all very clear when you're done with the electric sewing machine. Finally, i remind your friends that we must be serious about the use of the electric sewing machine, so don't lose sight of it, because it's easy to hurt our hands. I hope that the presentation will help you. For further information, please continue to focus on the web-based information platform。
