The electric kettle is an indispensable part of life today, and its convenience and speed make it easier for us. However, as electric kettles often work at high temperatures and use can inevitably be characterized by tides, splashes and even fallouts, there are also frequent failures. So what do we do with the electrical kettle failure and maintenance? Learn with the novelists, all of which you will find in life。
Steps for the use of electric hotpots
First step, remove the kettle from the power base。
Step two, press the opening button, open the kettle cap and pour water into the kettle, so that it does not exceed its maximum water level。
Step three, cover the kettle and place it on the power base。
Step four, press the power switch button, the power light is on and the kettle starts heating。
After the fifth step, when the water is turned on, the switch automatically shuts down the power signal. When the temperature switch is turned on, the temperature indicator light is on, the kettle starts to warm, and when the temperature is not maintained, the temperature switch is applied again, the kettle ceases to warm and the temperature indicator light is extinguished。
Electro-heat kettle failure and maintenance
Fault one: no heat after power. No light on
When the power switch is normal, it is likely to be a temperature protection switch to see if the springs of the two metal blades are pressurized by the switch trigger, and if they are pressured by a scorpion, bend them upwards, with a distance of 0. 5 to 1 mm. How the distance between the two is normal can be removed from the switch box and the contact points and reeds of the thermostat are cleaned and repaired。
Battery 2: no heat after electrical power, but signal lights on
In most cases, electrical thermal tubes or parts of their connection have malfunctions, such as damage and poor exposure to the electrothermal tubes, damage to the electrothermal tubes that can replace the new electrothermal tubes, which will result in poor exposure when the contact reeds in the power plug component are seriously corroded or deformed, and should be removed from the switch box and repaired and selected for replacement depending on the damage。
Cleaning and maintenance of electric kettles
As home-based drinking water appliances, care should be taken about safety when cleaning them. The clean-up steps are as follows:
1. Power sources shall be cut first。
2. Mix vinegar and water into the kettle at a 1:2 ratio and connect the power to automatically disconnect it。
3. A mixture of vinegar and water after burning shall prevent a 24-hour fall in the pot and connect to the power when the water is filled to the appropriate position。
4. At this point, the water in the canteen can be poured out of the canteen and taken with vinegar and then cleaned with water inside the canteen。
- - i'm a gorgeous dividing line - - -
