There are problems, more or less, in the use of the central air conditioner in sian york。
West anjok central air-construction one: machine presence at normal or low temperatures, causes of slow indoor cooling and solutions
1. The amount of wind delivery is less than the planned value, and the number of air exchanges is lower. See if the wind engine type is in accordance with the planning requirements, if the turn of the wheel is correct, if the belts are loose, if the vent valves are open and if there is a lack of wind flow factor。
2. There is a system of secondary wind return, and the secondary wind return is excessive。
3. The air-conditioning system is characterized by a large number of rooms and uneven distribution of wind。
Shenzhen york central air conditioning battery ii: systems measure more wind than planned cause and solution
1. The actual resistance of the system is less than that of the planned resistance, which increases the wind volume of the wind engine and allows for a change in the number of wind turbines when conditions exist。
2. The wind engine selected for the planning process is too large, so turn off the small wind control valve and reduce the volume。
West anjok central air conditioning fault iii: the systems measure less wind than the planned cause and solution
1. The operational resistance of the system is greater than that of the planned resistance, the amount of wind wind is reduced, and, when conditions are met, the wind tube components are improved and the resistance of the system reduced。
2. There is a congestion in the system。
3. System leakage, which should be addressed。
4. The wind engine does not reach planning capacity or the wheel is not in the right direction, the belt slips, etc., to see and exclude the factors that influence the wind engine's ability。
Shenzhen york central air conditioning fault four: indoor noise is greater than planning for cause and solution
1. Wind engine noise is above the rated value. The wind machine noise is measured to see if the wind engine wheel has touched the shell, if the bearings have been damaged, if the shock is good and if the symptoms are treated。
2. Wind pipes and valves, wind vents are too high and current noise occurs, so adjust valves and vents to reduce excessive wind speed。
3. The windpipe silencer is not complete. Please add the silencer node。
