Supor pressure pots are popular in the current market, and many households have chosen to use supor products, but, like domestic appliances, the supor pressure pots are out of order for a certain number of years and are frequently used in their use. What are the methods of repairing the supor pressure pot failure? Let's learn and understand
Fl: power lights are on, but no heat. The main cause of this failure was the failure of the heat drive, which was often burned。
Fault 2: start with a little heating, and the whole machine will automatically turn off the power and the lights will not turn on. This failure is mainly due to the failure of the temperature control at the bottom of the pot, which can only be heated before the temperature has broken off the power source, and when the temperature has fallen, the electricity is available in exchange for the temperature control。
Fault three: can't fit. The reason may be that the cover is covered or not in the right direction; the valves are stuck to the plate, resulting in the opening not being able to move freely; the seals or seals are not installed; and the pan caps or cooling covers are deformed by fall or impact. Method of repair: covered in the correct manner of the statement of instruction; plugged in the valve with chopsticks at the end of the valve; plugged the limit valve into the vent position or removed it, and then tied it to the cover; sealed fixed or sealed circle in the direction of the statement of instruction。
Fault four: i can't open it. There's pressure in the pot, agency lock, not open. To hit the pressure-limit valve to the “temperature” position. There is no pressure in the pot and the stop valves have not decreased due to the viscosity of the cooking. The valve shall be stabbed with a chopstick at the end of the valve. There is also the possibility that the shears are loose, leading to a shift in the shears. If it is stainless steel, it is possible that the screws are too long. This is when the handles are removed, the plate screws are re-set and silicone is fixed to replace the plate screws. The condensation of the pan cap on the heat shield resulted in the condensation of the concussion on the pancap on the teeth. The pan covers are to be rotated to the opening position, then the pan covers are to be pulled to the left and the pan covers are to be lifted。
Fault 5: the pan lid leaks and is accompanied by a loud sound: the main causes of this failure were: one, the unsealed seal or the unsealed seal; two, the ageing or broken seal; and three, if the sound inside the piercing pan is accompanied by a broken cup. Method of maintenance: 1. Installation of seals as required by the instructions; 2. Replacement of seals; 3. Replacement of cups。
Fault six: the food is not cooked. The proportion of rice is not correct, as required by the reference scale provided in the instructions. Open the lid during cooking. It's not allowed in cooking. There are foreign objects on the electro-thermal disk or double metal table temperature controls at the bottom due to radical transformation of the inner pan. At this point, the electro-heat disk and the inner pot are checked; the bottom two-metal tablet thermostat short circuits are retested and, if the problem is resolved, the thermostat can be replaced。
Fault vii: in the case of electrical pressure boiler failure, there are many times e3 problems, which indicate failure of the valve or of the clarinet. Such problems are suggested to check if the valve is stuck and the valve is cleaned out, and if the e4 beeper is shown to ring alarm, this means that the pressure switch is short and the pressure switch is burned。
