Watx1060 6g screen maintenance。
Ten notebooks。
Hello, everyone. I'm brother tung, the computer repairer. Today we're going to fix a gorgeous graphic card, which has not been taken apart. It's called gtx1060 6g。
The guest said that the card was plugged into the computer screen and then put it on the computer and turned it on。
All the flowers are on the screen when it's turned on. That's the stripes. When words appear on the desktop, the screen looks even stronger。
Once in the test software, it is automatically tested, but the images of the auto-test are stuck, as if they were dead, the interface is not back and there are no test results。
• only other versions of the test software can be restarted. Several versions of the test software were changed to find that there were times when the third was reported to be wrong or when the fourth was reported to be wrong。
• remove the radiator from the main plate. A magnifying glass was used to look at the main plate, without (detecting) water or corrosive areas, and a third visible deposit was replaced by a little welding on the visible。
• take down the third display with a windgun, clean up the welds, this is the visible welds, clean up and blow up the good visible windguns。
When stored, the stains on the visible surface are cleaned with shampoo。
• after cleaning it up, it was found to be the same screen, and the fourth display was removed and the welds cleaned up。
Welders for a good display, and soon the fourth will be ready。
Clean up the stains on the visible surface, press the gpu to spread the hot mud and get on board and see if it's flowery。
It's turned on. Put the heat on the gpu, load the fan, screw it。
• power-up to conduct a complete machine test and a visible test pass, no problem. Let's take a look at the test reports. They're all zeros。
• a different catalogue to test, or pass, and no mistake, so that there should be no problem with the presence. There is no problem with a visible pressure test。
• after entering the system, it was discovered that the drive of the graphic card was not in place, and then the drive of the graphic card was applied to confirm that it was shown in the device manager as gtx1060, in master lu as in the device manager。
· then a pressure test, the temperature pressure test ran for a while, looking at the temperature of the graphic card, the temperature of the graphic card is still about 48 degrees, which suggests that this card spread is quite good。
• then we'll run a graphic card performance test, which is still good, 164. 820。
And finally, we run its maximum test with tt circles, and the temperature is still still not above 70 degrees. It's been running for a while, which means the temperature is good。
Well, today's card maintenance is shared here, and thanks for watching。
