1. Collection of paper material. The flowers require two handmade origamis and tapes of 15 x 15 centimetres. A piece of paper for a tuber, so you can choose gray or green。
2. Choose a paper for flowers. If you have a pattern or a coloured side, you turn it out and turn it into a triangle, and turn it around to the left and right, and turn it into a small triangle, and finally open it。
Three, fold the petals. Turns the corner of the left triangle upwards along the crease in the middle, and this corner will be folded beyond the original triangle, roughly aligned with the top angle. That's the right corner. Try to symmetry around. Then put the flowers aside。
4. Place the paper used to fold the feathers, and the side with the pattern or colour is outward. It's folded and opened, and put it in a square drill。
Turn the right corner to the middle of the crease. Align the creases between the right edge of the paper to ensure that the lower end of the corner is also aligned. The left side is so folded, it's like a kite。
6. Collapse both sides to the middle. To ensure that the bottom is straight and sharp, the middle is tight。
7. Turn the corner above the right down to the middle of the crease, as does the left. And the two sides of the line are tight。
8. Decline the top of the kite to two thirds of the bottom of the kite. Left and right again. This little big triangle is the leaf。
Nine, roll up the bud, roll out a tip. Then drew the leaves out of the buds gently。
11. Done。
1. Take a handiwork paper 15 x 15 cm with a pattern outside. The two diagonals are folded one at a time to ensure that the angles and angles are aligned and that the creases are neat. The crease should be an "x" shape。
Turn the paper over. Right, right, right, and then open, and then up and down. Then your paper should be a rectangle。
Three, for the half of the bottom open, you press the upper left and upper right angles. The creases in the middle will rise, the four corners will be sewn at the bottom, and it should now form a square drill, flatten your square drill and make sure that the left and right symmetry is secured。
4. Rotate the diamonds 180 degrees, and the open part reaches the top。
5. Turn the left and the bottom of the diamonds to the middle. It'll look like a kite when it's finished. Turn the diamonds over and repeat the last step。
6. Open the petals. Grab the top of the kite. Crush it down to about three quarters with a thumb and an index finger, and press the middle of the flower to make the crease more visible。
7. The other petals are put in a flexible manner. Put the petals next to them where you want to put them。
8. Cutting edges into circles or scallops with scissors or florist cutters. The edge of the circle looks like a three-colour violet, scallops like carnation。
