The first two steps were simple and simple before the third. The most important is step three, why. Because i'm getting the total, and i'm sure a lot of people would think that it's easy to change the screen, and once it's on, it's done with a little effort. It is. But the purpose of sharing this experience today is to get more maintenance staff to learn the technique of dismantling the machine, and to make a greater profit, we all know how to do it, and i know that i'm just a rookie in mobile phone maintenance, and that there are more skilled maintenance personnel than me. I just want to share these good experiences with you and teach you good things. Okay, let's move on: how to get the screen out of the middle box, provided the internal and external screens are intact! It's usually a bit thicker than the layer torn off by the membrane. The back of this screen is glued in two parts, top and bottom, and there is a glue in the middle, which i don't know. It's covered in the back of the screen. It's on the back of the screen. It's solid and it's good to tear. First, the screen is heated on the separators, 70-80 degrees and one minute. Don't take too long, it's easy to break the lcd screen. There's a little trick here: we can get the upper and lower parts of the glue, heat the upper half, just a little bit down, that part. After a minute, the blade is plugged in along the gap between the screen and the frame, moving the blade slowly, moving in a little bit, not too big. It's best to have some alcohol on the blade. It's better to remove the glue. Try again and again according to this small step because it takes time to split the blades, not so much to separate them, and when the temperature is low, it doesn't. Then heated, heated and recycled so that the top half of the snacks could not be removed。
