The wetting function of the aging tester is mainly based on the use of dampers, so that in general the temperature of the cyanide test box is unstable and may be a wetting problem for the equipment. Standard group (hong kong) ltd. Is an aging equipment manufacturer, and the following is an introduction by the research and development engineer to the problems and solutions of the dampers, with a view to helping the client。
1. Insufficient wetting tanks。
Answer: water. Remove the pipe, lift the water tank and remove it from the base seat, reverse it, open the water lid and add a certain amount of water to the tank. When the water is finished, the water caps are tightened and the water caps and spring valves are checked. Is there a leak? The water tank is placed on the bottom cover - the water tank matches the bottom, as required by the matching。
2. Poor road connection to the aging test box。
Method of treatment: placing the wetter on the ground floor behind the right side of the artificial climate box, and then inserting the outlet into the gas pipe, keeping the outlet of the wetter with the entry of the artificial climate box at >3° angle, and slashing or flattening the plastic tube to avoid water clinking and blocking the road。
3. Circuit connectivity problems have arisen。
Method of handling: plugging electrical plugs in the right side and back of the wetter for use. The humidifier power is controlled by artificial climate boxes to ensure that it is wet or not。
In addition, in the event of a problem with the system of control of the test boxes for the ageing of lanterns or with the wetting of pumps, this situation will have to be addressed in contact with the technical staff of the plant, and it will be prohibited to remove the test boxes without permission for maintenance in order to avoid irreversible damage to the instruments and to repair them on its own, as well as problems with safety. Reporting to manufacturers is therefore a more effective solution。
