Canon printer 1 does not recognize cartridge maintenance。
Tell them that canon printers don't recognize the maintenance of the cartridges
1. Hello, everyone. A strange malfunction was shown today. This is an inkjet printer's inklift. Look at this position. This is the contact point of the ink cartridge, which is clean, and this is where the ink is, causing the machine to be incognito。
2. At this point, it seems okay to wipe it outside, but be careful to tear it apart, which is followed by ink in the position, as well as in the line。
3. The best solution would therefore be to tear it down and clean the trunks of the ink car thoroughly, otherwise the cartridges would be unidentifiable, so you would have to take care of them. It's not easy to look at this place like a chip, it's clean, but sometimes it's ink, and this one has to be noticed, or it's not working like me。
4. So now that the ink has been taken off, it is clear that this is a light mountain, which is not dirty, which can cause a line to be broken, or a belt to be too loose, or a line to be routed, so it is an experience that you need to look at. If it is not identified, it is important to observe the ink on the ink。
5. You can see, now that the ink has been taken off, then the black spot is also the light mountain that identifies the light mountains, so look, take off three or four screws and the third screw, there should be a lot of ink on this side, now take it off, see if it's all ink without all of it, if it's ink, and if it's also ink, it needs to be cleaned, and see if there's a chance that the line could be corrupted。
6. There are some originals on the table, and at this point it is necessary to take it seriously and clean it, and finally to see if it can be identified, and it is possible that the tablets will have to be scrapped, to show you, especially in colour, and now to wash it, to see if it's done well, to show you what it looks like after it has been wiped, to see how it's gonna get in here, with the cotton tags, with the no-water alcohol, to see how the ink might get in there。
7. Then install it and then wipe its head off。
