Eps fail-out method: in situ activation of the vehicle and several right-and-right shootings of the wheel; direct replacement of the twister sensor; repair of the damaged orientation machine or beam; removal of the abs sensor to clean up the dust on the top. The eps lights were mainly caused by power outages, power losses or the replacement of cylinders; the twisting sensor was broken; water was inserted inside the steering machine, or line plugs were corroded; and the abs sensor was damaged or dirty. 1. The failure of the pess as a result of power outages, power outages or the replacement of cylinders in vehicles was due to the loss of the transfer of modular data. Solutions: in such a case, the vehicle would have to be activated in situ and killed several times in the direction wheel, then driving the vehicle around 30-50 km, which would have automatically been removed. If failure lights cannot be removed by the above method, then rematch the data with a diagnostic device. 2. Torch sensors are damaged and the sensor's inner coil is damaged, which can also lead to the eps failure light. Solutions: direct replacement of the twister sensor will solve the problem, but care needs to be taken that if it is integrated into a twister sensor inside the engine, then the total of the engine will need to be replaced. 3. The entry of water within the direction aircraft, or the corrosion of the beams, leads to a malfunctioning light, and the vehicle's engine is located below the vehicle's chassis, which is bound to be covered with dust and dirt for prolonged use, leading to a malfunction. Solutions: repair of damaged directional machines or beams will solve the problem. 4. Abs sensors are damaged or dirty, which is a common cause of failure, mainly because the ps system collects abs data while working, and if the sensor is damaged, it indirectly leads to a failure of the ps light. Solutions: dismantling abs sensors, cleaning up the dust on top and reloading them back in the car. If the eps faillight is still on, it means the sensor is broken and needs to be replaced。
