Green fence cutters are high frequency (hf) use equipment for garden maintenance, complex environmental operations with open air, dusty and leaves throughout the years, and core components such as blades, electrics, hydraulic systems and batteries are vulnerable to foliage, dust and humidity. Many equipment failures, cardon, power shortages and reduced lifespans are not problems with equipment quality, but are the result of inadequate routine maintenance. The day-to-day maintenance of scientific norms can significantly improve the stability of equipment, extend its useful life and reduce the cost of later maintenance and replacement。
Blade blades are the most nuanced and worn-out parts of the cutter. Upon completion of each operation, the entanglement leaves, vines and muds in the slits of the blades are to be cleaned in time to avoid the residual impurity of the karton blades. Long-term residual debris can exacerbate the wear and tear of blades, leading to problems such as sharp cutting, tearing and shaking of equipment. At the same time, blade wear and tear must be regularly checked and the blades must be sharpened in a timely manner, and in the event of problems such as corrugated blades, crashes, deformations, etc., must be replaced in a timely manner so as not to affect the cutting effect and operational safety. Pre-storage can be preceded by minor stainproof oil to prevent rust from causing blades in an outdoor wet environment。
Maintenance of power systems requires different types of aircraft. Lithium money equipment is operated to clean up the body-heated vent dust, to ensure that it is ventilated and smooth, and to avoid the accumulation of dust leading to overheating and reduced power. Batteries need to be stored in a regular manner to avoid sunstorms, rain showers and cold storage, to be kept in a semi-electric state when they are not needed for long periods of time, to be banned from being fully charged or being held in deficit for long periods of time, and to effectively protect the circulation life of batteries. Fuel-for-fuel equipment is required to periodically replace oil, clean spark plug carbon, check air filter cores to ensure that engines are sufficiently gas-in and power output is stable。
Large vehicle-borne green fence cutters focus on the maintenance of hydraulic systems and stretching arm structures. There is a need to periodically check hydraulic fluid fluids and fluids, replace transform hydraulic fluids in a timely manner, clean hydraulic filter cores and prevent impurities from entering the oil road causing malfunctions such as cartons, depressions, failure to rise or fall. The axle and slide parts of the stretching arm are subject to regular embedding of lubricating oil to ensure a smooth stretching, uplifting, rotation, avoidance of dry wear, acoustic noise, karton, etc., and multi-angle operational accuracy。
In addition to this, the equipment is required to perform periodic overhauls of the circuits, interfaces, and fastenings to prevent long-term vibrations from causing screws to loose and lines to fall off. Upon completion of the operation, the machine is to be cleaned and stored in a dry ventilated room in order to avoid open rain. Standardized routine maintenance and periodic overhauls can effectively reduce equipment failure rates, allow green fence cutters to maintain stable operational performance over the long term and significantly reduce equipment acquisition and transport costs for landscaping units。
