And today, as modern offices have become popular, we can see all kinds of office supplies and related machines on our desks. We write articles or materials that no longer have to be done by hand, and we can do it with computers. This is especially true for mapping, where modern office software contains a lot of mapping software that we can easily do. It is easier to print than to use a plotter for the output of drawings. The plotter is used as a large drawing machine, but failure is common. So the following small part of the story is a brief description of some of the minor faults in the maintenance of the plotters and the method of their removal, which i would like to refer to。
The plotter, which is a large drawing device, is different from the average printer and has more sophisticated parts and more sophisticated machinery. Thus, problems can easily arise if the operation is poor or if maintenance is poor. The following sub-section provides a detailed description of some of the common problems of failure and how they have been eliminated。
The drawings are not good
Some friends, when they use a plotter to output drawings, feel that one side is tilted, and the whole picture is crooked after printing. But the one side that is not the rule is tilted. Such problems were mainly caused by problems with the steering wheel, which supported the handling of paper. There are, of course, cases where paper itself is a problem, where paper surfaces are smooth, and where there are membranes. Sometimes it is not because of the damage to the steering wheel, but because of the oily or dirty material that leads to irregular work. We just need to clean up the wheel。
I don't know what it's for
There are also many reasons for this, the first of which may be ink failure or ink shortage. This is usually reflected in computers. Regular supplementary cartridges, together with clean-out cartridges, can change the status quo. Another reason is the lack of clarity about the print quality as a result of the fact that there are a number of dirty objects produced in the machine as a result of long printing. We need to clean up the interior of the plotter on a regular basis。
It's not working
Sometimes we turn on the machine and find that the plotter doesn't work. This is because the usual large equipment needs preheating. Sometimes the heat can be preheated for 10 or 20 minutes. Sometimes the heat is short, just a few minutes. These are normal and long periods are caused by low ambient temperatures or procedural problems。
We have briefly described some of the simple failures and eliminations in the maintenance of the plotters, which, when used, need to be carefully maintained, so that some of the minor problems will not occur again。
