Common problems with toilet tiles are the sewing of the tiles, stitching problems, tile bubble problems in the bathrooms, and the front tiles in the bathrooms, all of which affect the quality of the tiles in the bathrooms and may even cause water leaks in the future. As a result, 10 toilet tile patches are provided by the tuba rabbits, which are noteworthy when they are applied。
1. The problem of sutures in toilet tiles
The tiles in the bathroom cannot be sewn too small, the tiles are sewn too small to reduce the useful life of the tiles, and the tiles crack their cheeks when they are condensed。
Recommendation: whether there is a sewn tile or a seamless tile, care must be taken to leave it open during construction. The polished bricks are 1 mm, 2-5 mm, imitated 5-8 mm。
2. Tileting in the bathroom
The fact that many of the workers who are now sewning are starting to do so as soon as the tiles in the bathroom are ready is highly inappropriate, as the tiles are not fully dry, which can easily result in the easing of the tiles during the course of the sewing, leaving them with safety risks。
Recommendation: cracks sew before they are dry. Usually any time after 24 hours。
Three. Cleaning up the bathroom before tiles
While some irresponsible construction teams were laying bricks on the walls, the greasy walls were put up with bricks, and the bricks were placed directly without shoveling them out. The security risks of this practice were very high, and, owing to the strength of the cement, the grub could not be attached to it, which could easily cause the tiles to fall off. It's not safe!
Recommendation: the wall must be examined before the bricks are pasted, and if there are cracks in the wall, the wall must be dealt with and cleaned。
4. Protection after toilet tiles are laid
The tiles are protected while they are laid, so that they are not cut and contaminated. The movement of dry brick surfaces, the painting of walls, and the non-use of protective film on the coating floor are frequent occurrences during the construction process, which can cause damage to tiles。
5. Tile-painting in the bathroom
When the bricks touch the angles of the sun, be careful not to break the tile layer, and close the links with a gap that cannot be too small。
6. The fall of tiles
Cement slurry is used to make adhesives when laying wall bricks, which have a high intake of water, and if they are not pre-integrated with water, the well-painted ceramic bricks absorb the moisture in the cement slurry. Cement requires a large amount of moisture during the process of solidification, and as the loss of water has become non-compressive and non-intensified, brick-coated cement sand has been removed from the wall together。
7. Quality of tiles in construction
Decoration companies are required to communicate with a in a timely manner on the quality of tiles during construction。
8 - implementation of the brick scheme before laying
Many of the workers in the construction work started laying as soon as they had taken the bricks, and when a certain degree of sowing was found to be ineffective and incoherent, the tiles were repaved, causing unnecessary losses and waste。
Recommendation: a well-painted separation plan is prepared prior to the paste。
9. Percentage of tile-painted sand
In order to prevent excessive constriction of the cement from causing greater stress pull to crack the tiles, it may be advisable to apply a low-marked cement 325 or less and 1:3。
10, tile bubble water, as required
A number of customers are now often seen returning unserviceable tiles, and some are found to be unable to return the goods because the tiles were overloaded. Current manufacturers or traders are generally not allowed to change, and the presence of exhausted tiles can cause unnecessary waste. Recommendation: the amount of bubbles needed, the amount of bubbles that can be built, not all of them, should be filled at once, and the amount of bubbles should be combined with the workers ' construction schedule。
